you, and your fingers must be resting on the other contacts. Avoid moving your hands. When your pulse is detected, the
For the most accurate heart rate reading, continue
to hold the handgrips for about 15 seconds. Note: When you first hold the handgrips, the display will show your heart rate continuously for 15 seconds.
The display will then show your heart rate along with the other feedback modes.
When you are finished exercising, the console
6 will automatically turn off.
If the pedals are not moved and the console but-
tons are not pressed for a few minutes, the con- sole will automatically turn off to conserve the
batteries.
HOW TO USE A PRESET PROGRAM
1 Turn on the console.
Refer to step 1 on page 12.
2 Select one of the four preset programs.
Each time the console is turned
on, the manual mode will be selected. To select a preset
program, press the Select
Program button repeatedly until the number 1, 2, 3, or 4 appears in the upper right corner of the display.
The profiles numbered 1 through 4 on the left side of the console show the resistance and pace settings for the preset programs.
3 Start the program.
To start the program, simply begin exercising. Each preset program consists of 30
resistance setting and/or pace setting may be programmed for consecutive periods.)
During the program, the resistance of the elliptical crosstrainer will automatically change as shown
by the applicable profile on the console. If the cur- rent resistance level is too high or too low, you can change the resistance level by pressing the Resistance buttons. However, when the current period of the program is completed, the resis-
tance level will automatically change if a different resistance setting is programmed for the next
period.
The pace set-
tings for the pro- gram will be shown by the right indicator in the display. (The
left indicator will show your actual
exercise pace.) As the right indicator changes during the program, simply increase or decrease your pace so that the same number of bars
appear in both indicators. If your pace is slower than the current pace setting, the increase arrow will appear in the display to prompt you to increase your pace; if your pace is faster than the pace setting, the decrease arrow will appear.
Important: The pace settings for the program are intended only to provide a goal. Your actu- al pace may be slower than the pace settings, especially during the first few months of your exercise program. Make sure to exercise at a pace that is comfortable for you.
During the program, the display will show the time remaining in the program. If you continue to exer- cise after the program is completed, the display will continue to show your exercise feedback.
4Follow your progress with the feedback modes.
Refer to step 4 on page 12.
5 Measure your heart rate if desired.
Refer to step 5 on page 12.
When you are finished exercising, the console
6 will automatically turn off.
Refer to step 6 above.
13