NordicTrack 831.159770 user manual

23. Remove the upper 3/8” x 3” Bolt (45) from the	23
Top Frame (1) and the Main Upright (3).
				35	55	54
Route the High Cable (73) around a 4” Pulley			Slot	45
(35) and down through the indicated slot in the
Main Upright (3), as shown. Attach the Pulley		50			42
inside the slot with a 3/8” x 2 1/2” Bolt (54), two						73
3/8” Washers (55), two 5/8” x 1/2” Bushings (42),
		1
and a 3/8” Nylon Jamnut (63).
Re-insert the 3/8” x 3” Bolt (45) and secure it with				42
a 3/8” Nylon Locknut (50). Note: The High Cable		63	55
(73) must be seated in the groove of the 4”
Pulley (35) before the Bolt is inserted.
				3
24. Route the High Cable (73) under the welded tube	24	Welded Tube
on the Press Frame (12) and around a 4” Pulley
						59
(35) as shown. Attach the Pulley to the Press
Frame with a 3/8” x 8 1/2” Bolt (59) and a 3/8”
Nylon Locknut (50).
		50			35
					73
				12
25. Wrap the High Cable (73) around a 4” Pulley (35).	25
Attach the Pulley inside the indicated slot in the
Main Upright (3) with a 3/8” x 2 1/2” Bolt (54), two					54
3/8” Washers (55), two 5/8” x 1/2” Bushings (42),
				42
and a 3/8” Nylon Jamnut (63).
Wrap the High Cable (73) around another 4” Pulley					55
(35) in the direction shown. Route the High Cable	35
through the slot in the Main Upright (3). Attach the
Pulley to the Press Frame (12) with a 3/8” x 8 1/2”	42					59
Bolt (59) and a 3/8” Nylon Locknut (50).
	63	55
		Slot		73
		50
				12	35
				3
	13