NordicTrack 831.159770 Adjustments, Changing the Weight Setting, Attaching the Accessories

Page 22

ADJUSTMENTS

The instructions below describe how each part of the weight system can be adjusted. Refer to the exercise guide accompanying this manual to see how the weight system should be set up for each exercise. IMPOR-

TANT: When attaching the lat bar, ankle strap, or ab strap, make sure that the accessories are in the cor- rect starting position for the exercise to be performed. If there is any slack in the cables or chain as an exercise is performed, the effectiveness of the exercise will be reduced.

CHANGING THE WEIGHT SETTING

To change the setting of the weight stack, insert the Weight Pin (39) under the desired Weight (26). Be sure to insert the Weight Pin until the bent end of the Weight Pin is touching the Weights, and turn the bent end downward. The setting of the weight stack can be changed from 10 pounds to 200 pounds, in incre- ments of 10 pounds. Note: Due to the cables and pulleys, the amount of resistance at each exercise station may vary from the weight setting. Use the WEIGHT RESISTANCE CHART on page 24 of this manual to find the approximate amount of resist- ance at each weight station.

ATTACHING THE ACCESSORIES

The Lat Bar (61), Ankle Strap (10), and Ab Strap (75) can be attached to the cable at the desired pulley sta- tion with a Cable Clip (69). For some exercises, the Chain (67) should be connected between the attach- ment and the cable with two Cable Clips. Adjust the length of the Chain between the accessory and the cable so the accessory is in the correct start- ing position for the exercise to be performed.

ADJUSTING THE HEIGHT OF THE SEAT

To adjust the height of the Seat (13), loosen the indi- cated Adjustment Knob (9). Pull out the Knob as far as possible and slide the Seat Upright (37) to the desired position. Release the Knob so that it engages one of the adjustment holes in the Seat Upright. Fully tighten the Knob.

USING THE LEG LEVER LOCK

Some exercises can be performed more comfortably with the Leg Lever (29) locked.

To lock the Leg Lever (29), turn the Leg Lever Lock

(11)until it engages the Pad Tube (28) on the Leg Lever.

26

 

39

 

69

 

67

 

69

75

10

61

 

 

13

9

 

37

 

29

 

11

 

28

 

22

 

Image 22
Contents Model No Serial No QUESTIONS?Customer HOT Line Table of Contents Important Precautions Before YOU Begin DecalAssembly Make Assembly Easier for YourselfFrame Assembly Open the parts bag labeled Weight Inserts Make sure the large pin groove is oriented as shownLocknut onto the upper Bolt yet Tighten the 3/8 Nylon Locknuts 50 used in steps 1BLY Arm AssemblyOpen the parts bags labeled ARM Assem Has an extra hole in itDo not overtighten the Nylon Locknut Leg Lever Lock must pivot easilyCable Assembly Page Page Page Page Two Pulley Plates 31. Make sure the Cable is Is oriented so it will hold the Cable in placeAssembly Seat AssemblyOpen the parts bag labeled ARM and Seat Page Page Page Cable Diagram Attaching the Accessories AdjustmentsChanging the Weight Setting Adjusting the Height of the SeatConverting the PRESS/FLY Arms Attaching the Curl PADWeight Press Low High Leg Plates Arm Pulley Weight Resistance ChartLbs TROUBLE-SHOOTING and Maintenance Tightening the CablesExercise Guidelines Cooling Down Muscle ChartStaying Motivated Ordering Replacement Parts Limited WarrantyPage 3 Inner Cap Page Part Identification CHART-Model No .159770 R0402A Remove this Part LIST/EXPLODED Drawing From the Manual Part LIST-Model No Qty Description831 Exploded159770