NordicTrack 831.159770 user manual Cable Assembly

Cable Assembly	16
				63
16. Open the parts bags labeled “CABLE ASSEM-					76
BLY” and “4 PULLEYS.” Refer to the CABLE
DIAGRAM on page 21 to identify the cables			84	55	90
and for correct cable routing.
Locate the Leg Press Cable (76). Attach the Leg	45
Press Cable to the indicated hole in the Leg
Press Base (84) with a 3/8” x 3” Bolt (45), two			55
3/8” Washers (55), a 5/8” x 1/4” Bushing (90), and
a 3/8” Nylon Jamnut (63).
17. Wrap the Leg Press Cable (76) up around a 4”	17
Pulley (35). Attach the Pulley and a Cable Trap
				97
(44) to the Rear Leg Press Upright (97) with a 3/8”
x 3 3/4” Bolt (92), a 3/8” Washer (55), and a 3/8”
Nylon Locknut (50).					92
Be sure that the Leg Press Cable (76) is rout-				35	44
ed in the direction shown, and that the Cable
Trap (44) is positioned to hold the Cable in the				76
pulley groove.
	50		55
18. Route the Leg Press Cable (76) under a 4” Pulley	18
(35). Attach the Pulley and a Cable Trap (44) to
the Leg Press Base (84) with a 3/8” x 3 3/4” Bolt
(92), a 3/8” Washer (55), and a 3/8” Nylon
Locknut (50). Be sure that the Cable Trap (44)		76
is positioned to hold the Cable in the pulley
groove.				44
				92
				35
	50		55
			84
19. Wrap the Leg Press Cable (76) around a 4”	19
Pulley (35). Attach the Pulley and a Cable Trap
(44) to the 3/8” x 5” Carriage Bolt (82) in the			50
Stabilizer (5) with a 3/8” Nylon Locknut (50).			35
Be sure that the Leg Press Cable (76) is rout-		44
ed in the direction shown, and that the Cable	76
Trap (44) is positioned to hold the Cable in the
			82
pulley groove.
			5
	11