Top | NordicTrack NTL13007.0 manual

Raise the Uprights (85) to the vertical position. Remove the three #8 x 3/4" Screws (7) from the Hood (33), and carefully pivot the Hood off.

85	7
33

Locate the Reed Switch (22) and the Magnet (18) on	Top
the left side of the Pulley (17). Turn the Pulley until the	Top
Magnet is aligned with the Reed Switch. Make sure	View
Magnet is aligned with the Reed Switch. Make sure
that the gap between the Magnet and the Reed		17
Switch is about 1/8 in. (3 mm). If necessary, move	22	17
Switch is about 1/8 in. (3 mm). If necessary, move		18
the Reed Switch slightly using a slotted screwdriver.
the Reed Switch slightly using a slotted screwdriver.
Reattach the Motor Hood (not shown), making sure	1/8 in.
that the #8 x 3/4" Screws (not shown) are inserted into
the same holes from which they were removed.
Reattach the Hood (not shown). Tip down the

Uprights (not shown), reattach the Belly Pan Screws

(not shown), and raise the Uprights. Run the treadmill for a few minutes to check for a correct speed reading.

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 14.

b. If the walking belt is overtightened, treadmill perfor- mance may decrease and the walking belt may be- come damaged. Remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both rear roller bolts counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 3 to 4 in. (8 to 10 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is properly tightened.

b	3–4 in.

Rear Roller Bolts

c. If the walking belt still slows when walked on, please see the front cover of this manual.

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION: a. If the walking belt is off-center, remove the key and UNPLUG THE POWER CORD. If the walking belt has shifted to the left, use the hex key to turn the left rear roller bolt clockwise 1/2 of a turn; if the walk- ing belt has shifted to the right, turn the left rear roller bolt counterclockwise 1/2 of a turn. Be careful not to overtighten the walking belt. Plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is centered.