ParaBody 400102 manual 37 3/8 X

Page 14

	37 3/8 X 2”
	51	58	79
		58	79
	21
	51
FIGURE 18	48
FIGURE 18

STEP 18

•Loosely assemble two 3-1/2” PULLEYS (79) and two 2-3/8” CABLE RETAINING CLIPS (58) to the CENTER PULLEY BRACKET (21) using two 3/8 X 2” BOLTS (37), four 3/8” WASHERS (51), and two 3/8” LOCKNUTS (48). See FIGURE 18.

(NOTE: This connection will be tightened after the cable has been routed.)

	87
	17
49	52
	52
	21
	45 1/2 X 4-1/2”
	11
FIGURE 19

STEP 19

•Securely assemble the BEARING HOUSING (17) and the CENTER PULLEY BRACKEY (21) to the FRONT UPRIGHT (11) as shown in FIGURE 19, using two 1/2 X 4-1/2” BOLTS (45), four 1/2” WASHERS (52), and two 1/2” LOCKNUTS (49). (NOTE:

The conntector plates on the BEARING HOUSING (17) and the CENTER PULLEY BRACKET (21) have slotted holes. Shift the BEARING HOUSING (17) down as far as possible and the CENTER PULLEY BRACKET (21) up as far as possible before tightening.)

•Attach two 1” X 1” GLIDES (87) to plate on the BEARING HOUSING (17) as shown.

14

Image 14

Contents Home GYM Bolt Length Ruler Parts List KEY Description QTYStep 50 1/2 LOW Height X 3-3/4 42 1/2 X X 3-3/4 42 1/2 X LOW Height TAB Ways Allow Spring PIN Assembly to Fully Engage Step DetailLocknuts 38 3/8 X 2-3/4 Silicon or teflon spray available at most hard Ware stores Tighten 37 3/8 X Roller PAD 32 with rubbing alcohol or water. Also X 3 47 1/2 X 5-1/2 42 1/2 X 50 1/2 LOW HT NUT 48. Note Make sure LEG EXT Lowheight LOCKNUT50.NOTEAssemble one 3-1/2 Pulley 79 to the Floating Pulley Cable Guide Step Step Step 36 3/8 X 1-3/4 See Detail Cableadjustment Upperfloatingpulleybracket AdjustmentAdjustment Lowerfloating Pulleybracket Step