ParaBody 400102 manual X 3 47 1/2 X 5-1/2 42 1/2 X

	1
	55
	2	54
		95
FIGURE 21	71

STEP 21

•Slide the 1/2” DIAU-PIN (55) through the bushing in the WOLFF SLEEVE (2) then force 1/2” PAL NUT (54) over end of 1/2” DIAU-PIN (55).

•Slide the WOLFF SLEEVE (2) over the FRAME SUPPORT (1). (NOTE: Make sure the spring pin barrel is facing as shown in FIGURE 21.)

•Securely assemb1e one 3/8” SPRING PIN ASSEMBLY (71) and one THUMBSCREW (95) to the WOLFF SLEEVE (2).

1
	50 1/2” LOW
	HEIGHT
		50 1/2” LOW
		HEIGHT
18	1/2 X 3” 42
		15
47 1/2 X 5-1/2”	10
		52
	49	42 1/2 X 3”
FIGURE 22

STEP 22

•Securely fasten the LEG SUPPORT (15) to the BASE (10) using two 1/2 X 3” BOLTS (42), two 1/2” WASHERS (52) and two 1/2” LOCKNUTS (49).

•Securely attach FRAME SUPPORT (1) to the LEG SUPPORT (15) using one 1/2” X 3” BOLT (42) and one 1/2” LOW HEIGHT LOCKNUT (50) as shown in FIGURE 22.

•Attach two 2 X 16-1/2” PLATES (18) to the FRAME SUPPORT (1) using one 1/2 X 5-1/2” BOLT (47), and one 1/2” LOW HEIGHT LOCKNUT (50) as shown on FIGURE 22. (NOTE: Securely tighten, then back nut off 1/4 turn to allow the 2 X 16-1/2” PLATES (18) to rotate freely.)

16