ParaBody 400102 manual Step

Page 4

16

 

69

 

49

 

52

79

 

 

48

 

66

1/2 X 3” 42

10

 

66

3/8 X 2-3/4”

38

 

90

FIGURE 1

 

STEP 1

•Securely assemble REAR UPRIGHT (16 ) to BASE (10) using two 1/2 X 3" BOLTS (42), two 1/2" WASHERS (52), and two 1/2" LOCKNUTS (49).

•Slide LEG EXT. CABLE ASSEMBLY (90) through openings in BASE (10) as shown in FIGURE 1.

•Securely assembe two 3-1/2" PULLEYS (79) into BASE (10) using two 3/8 X 2-3/4" BOLTS (38), four 3/8" FLANGE SPACERS (66), and two 3/8" LOCKNUTS (48). (NOTE: Make sure LEG EXT. CABLEASSEMBLY (90) is routed under PULLEYS and BOLTS.)

•Slide LEG EXT. CABLE ASSEMBLY (90) through the opening in the end of the BASE (10) as shown in FIGURE 1.

•Insert four 3/4" FLANGE BEARINGS (69) into tubes on REAR UPRIGHT (16) as shown in FIGURE 1

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Home GYM Bolt Length Ruler Parts List KEY Description QTYStep 50 1/2 LOW Height X 3-3/4 42 1/2 X X 3-3/4 42 1/2 X LOW Height TAB Ways Allow Spring PIN Assembly to Fully Engage Step DetailLocknuts 38 3/8 X 2-3/4 Silicon or teflon spray available at most hard Ware stores Tighten 37 3/8 X Roller PAD 32 with rubbing alcohol or water. Also X 3 47 1/2 X 5-1/2 42 1/2 X 50 1/2 LOW HT NUT 48. Note Make sure LEG EXT Lowheight LOCKNUT50.NOTEAssemble one 3-1/2 Pulley 79 to the Floating Pulley Cable Guide Step Step Step 36 3/8 X 1-3/4 See Detail Cableadjustment Adjustment Lowerfloating Pulleybracket AdjustmentUpperfloatingpulleybracket Step
Top Page Image Contents