ParaBody 400102 manual LOW Height

STEP 5

•Insert two 1/2" FLANGE BEARINGS (67) into RECEIVING TUBE (13).

•Attach RECEIVING TUBE (13) to PRESS ARM LEVER

(9) using one 1/2 X 3-1/2" BOLT (43), and 1/2" LOW HEIGHT LOCKNUT (50). (NOTE: Securely tighten, then back nut off 1/4 turn to allow the RECEIVING TUBE (13) to rotate freely.)

•Insert the ADJUSTMENT TUBE (6) into the RECEIVING TUBE (13) as shown in FIGURE 5.

9

1/2 X 3-1/2” 43

FIGURE 5

6

13

67

50

1/2”

LOW

HEIGHT

16

67

8

29

FIGURE 6

STEP 6

•Slide one 3/4 DIA X 11" SHAFT (29) through PRESS ARM (8) & tube on REAR UPRIGHT (16). See FIGURE 6.

•Insert two 1/2" FLANGE BEARINGS (67) into PRESS ARM (8).

	1/2		1/2		1/2		1/2		1/2		1/2
0		1		2		3		4		5	6

7