ParaBody 400102 manual Assemble one 3-1/2 Pulley 79 to the Floating Pulley

Page 19

		1
			4
	30
31	0	1/2	1/2	1/2	1/2	4
	0		1	2	3	4
73					FIGURE 26

STEP 26

•Assemble four ROLLER PADS (31) to the LEG CURL/EXTENSION (4) as shown on FIGURE 26 using two 16” TUBES (30) and four STARLOCK COLLARS (73).

•Assemble two ROLLER PAD (31) to the tubes on FRAME SUPPORT (1) using two STARLOCK COLLARS (73) as shown in FIGURE 26..

	48	STEP 27
	48
	79	• Assemble one 3-1/2” PULLEY (79) to the FLOATING PULLEY
22	79	BRACKET (22) using one 3/8 X 1-3/4” BOLT (36) and one 3/8”
22		LOCKNUT (48) as shown in FIGURE 27.
		LOCKNUT (48) as shown in FIGURE 27.
36 3/8 X 1-3/4”
FIGURE 27
		19

Image 19

Contents Home GYM Bolt Length Ruler KEY Description QTY Parts ListStep 50 1/2 LOW Height X 3-3/4 42 1/2 X X 3-3/4 42 1/2 X LOW Height TAB Detail Ways Allow Spring PIN Assembly to Fully Engage StepLocknuts 38 3/8 X 2-3/4 Silicon or teflon spray available at most hard Ware stores Tighten 37 3/8 X Roller PAD 32 with rubbing alcohol or water. Also X 3 47 1/2 X 5-1/2 42 1/2 X 50 1/2 LOW HT Lowheight LOCKNUT50.NOTE NUT 48. Note Make sure LEG EXTAssemble one 3-1/2 Pulley 79 to the Floating Pulley Cable Guide Step Step Step 36 3/8 X 1-3/4 See Detail Cableadjustment Adjustment Lowerfloating Pulleybracket AdjustmentUpperfloatingpulleybracket Step