93 |
5 |
91 |
FIGURE |
38 |
FIGURE 39 |
92 |
81 |
74 |
57 |
12 |
26 |
STEP 38
•Screw the threaded end of AB CABLE (91) ap- proximately 3/4” into the end of the PULLEY BRACKET (5) and tighten jam nut securely as shown in FIGURE 38.
•IMPORTANT! Make sure the cables are running in the grooves of all pulleys.
CABLEADJUSTMENT
For maximum performance, the HEAD PLATE should should just barely sit on the top WEIGHT PLATE and the UPPER FLOATING PULLEY BRACKET should firmly contact the PLATE on the TOPBOOM, and the LOWER FLOATING PULLEY BRACKET should firmly contact the BASE.
•The following adjustments can be made to adjust the cable tension:
•If upon completion of assembly, the HEAD PLATE (81) does not sit on top of the first WEIGHT PLATE (74), push the HEAD PLATE (81) down, insert the WEIGHT STACK PIN (57) and perform several repetitions at the press sta- tion. This will relax the cable system and prevent the HEAD PLATE (81) from lifting up.
•If after completing previous step, the HEAD PLATE (81) still does not sit on top of the first WEIGHT PLATE (74) or if there is excess slack in the cable system, adjust the threaded end of the LAT CABLE (92) accordingly and retighten the jam nut.
•If there is excess slack in the LEG CABLE, move the PULLEY attached to the LEVER STOP (12) down one hole.
•If there is excess slack in the AB or PEC DEC cable system, adjust the threaded end of the AB CABLE (91) accordingly and retighten the jam nut.
•IMPORTANT! Retighten both jam nuts when adjustment is completed.