ParaBody 400102 manual NUT 48. Note Make sure LEG EXT, Lowheight LOCKNUT50.NOTE

	26	28
		14
		78
	51	51
3/8 X 2-3/4”	38	35 3/8 X 1”
FIGURE 24

STEP 24

•Securely attach BACK SEAT PAD (26) to BACK PAD SUPPORT (14) using two 3/8 X 2-3/4” (38) and two 3/8” WASHERS (51).

•Securely attach LEG SEAT PAD (28) to HINGE TABS (78) using two 3/8 X 1” (35) and two 3/8” WASHERS (51) as shown in FIGURE 24.

STEP 25

Assemble the LEG CURL/EXTENSION (4) to the LEG SUPPORT (15) using the following steps:

				FIGURE 25	• Assemble one 3-1/2” PULLEY(79) to the LEG
					SUPPORT (15) using one 3/8 X 3” BOLT (39),
					two 3/8 X 1/2” SPACERS (99), one CABLE
					RETAINING CLIP (58) and one 3/8” LOCK
				97	NUT (48). (NOTE: Make sure LEG EXT.
			98		CABLE (90) is running under the PULLEY.)
					• Insert two 1/2” FLANGE BEARINGS (67)
			50	1/2” LOW	into the LEG CURL/EXTENSION (4).
				HEIGHT	• Assemble the LEG CURL/EXTENSION (4) to
					the BENCH FRAME (15) using one 1/2 X 3”
				67	(42), two BOLT COVER CAPS (97), two
					BOLT COVER WASHERS (98) and one 1/2”
	98
97		58	99		LOWHEIGHTLOCKNUT(50).(NOTE:
					Securely tighten, then back nut off 1/4 turn
	79		48
					to allow the LEG CURL/EXTENSION (4) to
					rotate freely.)
					• Assemble the ball end of the LEG EXT.
	99			4	CABLE (90) to the KEYHOLE CLEVIS (100)
			100		as shown in FIGURE 25.
42 1/2 X 3”				48	• SECURE the KEYHOLE CLEVIS (100) to the
			90
					tab on the LEG CURL/EXTENSION (4) using
					one 3/8 X 1” BOLT (35) and one 3/8” LOCK
39 3/8 X 3”			35 3/8 X 1”		NUT (48) as shown in FIGURE 25. (NOTE:
					Do not overtighten! Keyhole clevis should
				18	rotate freely.)