ParaBody 400102 manual 50 1/2 LOW HT

Page 17

	14
	50 1/2” LOW HT.
TIGHTEN	85
	85
	50 1/2” LOW HT.
1	18
1
	2
47 1/2 X 5-1/2”
TIGHTEN
43 1/2 X 3-1/2”
	10
	78
FIGURE 23

STEP 23

•Attach WOLFF SLEEVE (2) to the BACK PAD SUPPORT (14) using one 1/2 X 3-1/2” BOLT (43) and one 1/2” LOW HEIGHT LOCKNUT (50). (NOTE: Securely tighten, then back nut off 1/4 turn to allow the BACK PAD SUPPORT (14) to rotate freely.) See FIGURE 23.

•Attach both 2 X 16-1/2” PLATES (18) to the bushing on the BACK PAD SUPPORT (14) using one 1/2 X 5-1/2” BOLT (47) and one 1/2” LOW HEIGHT LOCKNUT (50). (NOTE: Securely tighten, then back nut off 1/4 turn to allow the 2 X 16-1/2” PLATES (18) to rotate freely.) See FIGURE 23.

•Slide one HINGE TAB (78) on each side of shaft on WOLFF SLEEVE (2). See FIGURE 23.

•Stick one 1-1/4” RUBBER BUMPER (85) on the BACK PAD SUPPORT (14) approximately 1/2” from the end of BACK PAD SUPPORT (14).

•At this time, SECURELY tighten the FRAME SUPPORT (1) to the BASE (10) and the FRONT UPRIGHT (11).

	1/2		1/2		1/2		1/2		1/2			1/2
0		1		2		3		4		5		6

17

Image 17

Contents Home GYM Bolt Length Ruler KEY Description QTY Parts ListStep 50 1/2 LOW Height X 3-3/4 42 1/2 X X 3-3/4 42 1/2 X LOW Height TAB Detail Ways Allow Spring PIN Assembly to Fully Engage StepLocknuts 38 3/8 X 2-3/4 Silicon or teflon spray available at most hard Ware stores Tighten 37 3/8 X Roller PAD 32 with rubbing alcohol or water. Also X 3 47 1/2 X 5-1/2 42 1/2 X 50 1/2 LOW HT Lowheight LOCKNUT50.NOTE NUT 48. Note Make sure LEG EXTAssemble one 3-1/2 Pulley 79 to the Floating Pulley Cable Guide Step Step Step 36 3/8 X 1-3/4 See Detail Cableadjustment Upperfloatingpulleybracket AdjustmentAdjustment Lowerfloating Pulleybracket Step