Bowflex 001-7057 manual Assembly Unboxing, Step

Page 10

10

Assembly (Unboxing)

WA R N I N G

Warning: The Bowflex Revolution®XP Home Gym is very heavy. Whenever possible use two people to unbox the main unit.

We have designed the packaging to make unboxing the main unit as safe and easy as possible.

NOTE: Some of the hardware needed for unboxing is located on the Box 3 Hardware Card

Step 1

Open top flaps

Top layer of styrofoam

1-1Open the top flaps of Box 2 (Figure A) and split the corners along the perforations to expose the top layer of styrofoam. (Figure B)

Figure A

Step 2

Rear Stabilizer Hardware

Rear Stabilizer

2-1Remove the Rear Stabilizer, and Hardware Pack, (Figure C) then remove the top layer of styrofoam to expose the lower portion of the Main Frame. (Figure D)

The two Foot Caps that are packaged in this box will be installed in Step 6. (Figure E)

Figure C

Foot Caps

Split box corners along perforations

Figure B

Top layer of

styrofoam

Lower portion of

Main Frame

Figure D

Figure E

Image 10
Contents Home Gym Table of Contents Before You StartTools You Will Need Hardware Card BoxHardware Hardware Hardware Card Box Box Contents Box 1 ContentsBox 2 Contents Box 3 Contents Box 4 Contents Assembly Unboxing StepAssemble Rear Stabilizer Rubber Pads Box 3 hardware cardInstall Rear Stabilizer Install Stabilizers and Lower Lat Connector HardwareStep Separate styrofoam Packing Lift box Styrofoam packing Remove Top Cover AssemblyRemove Styrofoam Inner Packing Install Tension Shaft Tighten Tension Shaft Holder Install Pre-Tension SpiraFlex Packs Remove Cam HoldersAdjusting Cable Tension Replace Top CoverAssembly Adjusting Cable Tension Install Seat Support PlatesInstall Seat Tube Seat Tube CapInstall Cable Hooks Rope Hooks Box 3 Hardware CardInstall Pulleys Figure aInstall Back Pad Install Seat PadAttaching Seat and Back Pad Assemble Leg Extension End Caps Box 4 Hardware CardInstall Cables Figure a CableApply Revolution XP Decal Final Inspection Important Contact Numbers For assistance