Bowflex 001-7057 manual Install Cables, Figure a Cable

Page 28

28

Assembly

Step 25 Install Cables

Parts:

• Ropes (Box 3)

25-1Remove the Ball End from the cable by pressing the insert out of the ball (Figure A) and slide the ball off of the cable.

25-2Route the cable under the Pulley closest to the Main Unit and reinstall the Ball End (Figure B).

Pulley

Figure A

Cable

Figure B

NOTE: When not in use, store the cable by wrapping it around the Cable Hooks as shown.

Hooks

Image 28

Contents Home Gym Table of Contents Before You StartTools You Will Need Hardware Card BoxHardware Hardware Hardware Card Box Box Contents Box 1 ContentsBox 2 Contents Box 3 Contents Box 4 Contents Assembly Unboxing StepAssemble Rear Stabilizer Rubber Pads Box 3 hardware cardInstall Rear Stabilizer Install Stabilizers and Lower Lat Connector HardwareStep Separate styrofoam Packing Lift box Styrofoam packing Remove Top Cover AssemblyRemove Styrofoam Inner Packing Install Tension Shaft Tighten Tension Shaft Holder Install Pre-Tension SpiraFlex Packs Remove Cam HoldersAdjusting Cable Tension Replace Top CoverAssembly Adjusting Cable Tension Install Seat Support PlatesInstall Seat Tube Seat Tube CapInstall Cable Hooks Rope Hooks Box 3 Hardware CardInstall Pulleys Figure aInstall Back Pad Install Seat PadAttaching Seat and Back Pad Assemble Leg Extension End Caps Box 4 Hardware CardInstall Cables Figure a CableApply Revolution XP Decal Final Inspection Important Contact Numbers For assistance