Bowflex 001-7057 manual Step

Page 14
3/8” Washer

14

Assembly (Unboxing)

Step 6

3/8 x 2 3/4 ” Button Head

 

Cap Screw

Parts:

• Platform (Box 3)

• Foot Caps (Box 2)

Tools:

• 7/32” Allen Wrench

• 9/16” Wrench or Adjustable Wrench

6-1Align Platform with Stabilizers making sure the rubber pads are pointing downward.

3/8” Nylock Nut

6-2Install DO NOT TIGHTEN the hardware.

6-3Install Foot Caps onto the ends of the Stabilizers.

Hardware (1:1):

3/8” Washer

6 Button Head Cap Screw (3/8” X 2 3/4”)

12 Washer (3/8”)

6 Nylock Nut (3/8”)

Step 7

With the help of a partner, slowly roll the box completely over so the unit rests on the Rear Stabilizer and Platform.

Image 14
Contents Home Gym Table of Contents Before You StartTools You Will Need Hardware Card BoxHardware Hardware Hardware Card Box Box Contents Box 1 ContentsBox 2 Contents Box 3 Contents Box 4 Contents Assembly Unboxing StepAssemble Rear Stabilizer Rubber Pads Box 3 hardware cardInstall Rear Stabilizer Install Stabilizers and Lower Lat Connector HardwareStep Separate styrofoam Packing Lift box Styrofoam packing Remove Styrofoam Inner Packing AssemblyRemove Top Cover Install Tension Shaft Tighten Tension Shaft Holder Install Pre-Tension SpiraFlex Packs Remove Cam HoldersAdjusting Cable Tension Replace Top CoverAssembly Adjusting Cable Tension Install Seat Support PlatesInstall Seat Tube Seat Tube CapInstall Cable Hooks Rope Hooks Box 3 Hardware CardInstall Pulleys Figure aInstall Back Pad Install Seat PadAttaching Seat and Back Pad Assemble Leg Extension End Caps Box 4 Hardware CardInstall Cables Figure a CableApply Revolution XP Decal Final Inspection Important Contact Numbers For assistance