Bowflex 001-7057 manual Assembly, Remove Top Cover, Remove Styrofoam Inner Packing

Page 16

16

Assembly

Step 10 Remove Top Cover

Tools:

• 1/8” Allen wrench

10-1Use a 1/8” Allen Wrench to remove the four screws in the Top Cover, then remove

the Top Cover and set it aside. Set screws aside for Step 16.

Step 11 Remove Styrofoam Inner Packing

11-1Remove and discard the three pieces of Styrofoam Inner Packing.

Note: You must open the plastic bag

and remove each piece of styrofoam individually.

Top Cover

Remove screws

Remove front piece first

Styrofoam Packing

Image 16

Contents Home Gym Table of Contents Before You StartTools You Will Need Hardware Card BoxHardware Hardware Hardware Card Box Box Contents Box 1 ContentsBox 2 Contents Box 3 Contents Box 4 Contents Assembly Unboxing StepAssemble Rear Stabilizer Rubber Pads Box 3 hardware cardInstall Rear Stabilizer Install Stabilizers and Lower Lat Connector HardwareStep Separate styrofoam Packing Lift box Styrofoam packing Remove Top Cover AssemblyRemove Styrofoam Inner Packing Install Tension Shaft Tighten Tension Shaft Holder Install Pre-Tension SpiraFlex Packs Remove Cam HoldersAdjusting Cable Tension Replace Top CoverAssembly Adjusting Cable Tension Install Seat Support PlatesInstall Seat Tube Seat Tube CapInstall Cable Hooks Rope Hooks Box 3 Hardware CardInstall Pulleys Figure aInstall Back Pad Install Seat PadAttaching Seat and Back Pad Assemble Leg Extension End Caps Box 4 Hardware CardInstall Cables Figure a CableApply Revolution XP Decal Final Inspection Important Contact Numbers For assistance