Bowflex 001-7057 manual Attaching Seat and Back Pad

Page 26

26

Assembly

Attaching Seat and Back Pad

Attach the Seat and Back Pad to the Main unit by placing the Upper Hooks onto the respective Upper Post and rotating the Lower Hook into position.

Once the Seat Pad is in postion, insert the Locking Pin through the hole behind the Lower Hook to secure the pad to the Seat Tube.

Upper Hook

Upper Post

Back Pad

Upper Hook

Seat Pad

Locking Pin

Upper Post

Image 26

Contents Home Gym Table of Contents Before You StartTools You Will Need Hardware Card BoxHardware Hardware Hardware Card Box Box Contents Box 1 ContentsBox 2 Contents Box 3 Contents Box 4 Contents Assembly Unboxing StepAssemble Rear Stabilizer Rubber Pads Box 3 hardware cardInstall Rear Stabilizer Install Stabilizers and Lower Lat Connector HardwareStep Separate styrofoam Packing Lift box Styrofoam packing Remove Styrofoam Inner Packing AssemblyRemove Top Cover Install Tension Shaft Tighten Tension Shaft Holder Install Pre-Tension SpiraFlex Packs Remove Cam HoldersAdjusting Cable Tension Replace Top CoverAssembly Adjusting Cable Tension Install Seat Support PlatesInstall Seat Tube Seat Tube Cap Install Cable Hooks Rope Hooks Box 3 Hardware CardInstall Pulleys Figure aInstall Back Pad Install Seat PadAttaching Seat and Back Pad Assemble Leg Extension End Caps Box 4 Hardware CardInstall Cables Figure a CableApply Revolution XP Decal Final Inspection Important Contact Numbers For assistance