Bowflex 001-7057 manual Install Tension Shaft

Page 17

Assembly

17

Step 12 Install Tension Shaft

Parts:

• Main Unit

• Shaft (Box 3)

Main unit

Rounded edge on top

12-1Align the rounded side of the Tension Shaft with the rounded side of the hole in the Main Unit and slowly slide the Shaft through until it clicks into place.

If the Shaft is obstructed inside the Main Unit, loosen the tension screws in the Tension Shaft Holder (see Step 13).

Shaft

Note: If you didn’t feel or hear a distinct click, make sure the shaft is centered by measuring the amount of exposed shaft on each side of the Main Unit. There should be an equal measure on each side.

Image 17

Contents Home Gym Before You Start Table of ContentsHardware Card Box Tools You Will NeedHardware Hardware Hardware Card Box Box 1 Contents Box ContentsBox 2 Contents Box 3 Contents Box 4 Contents Step Assembly UnboxingRubber Pads Box 3 hardware card Assemble Rear StabilizerInstall Rear Stabilizer Hardware Install Stabilizers and Lower Lat ConnectorStep Separate styrofoam Packing Lift box Styrofoam packing Remove Styrofoam Inner Packing AssemblyRemove Top Cover Install Tension Shaft Tighten Tension Shaft Holder Remove Cam Holders Install Pre-Tension SpiraFlex PacksReplace Top Cover Adjusting Cable TensionInstall Seat Support Plates Assembly Adjusting Cable TensionSeat Tube Cap Install Seat TubeRope Hooks Box 3 Hardware Card Install Cable HooksFigure a Install PulleysInstall Seat Pad Install Back PadAttaching Seat and Back Pad End Caps Box 4 Hardware Card Assemble Leg ExtensionFigure a Cable Install CablesApply Revolution XP Decal Final Inspection Important Contact Numbers For assistance