Bowflex 001-7057 manual Install Cable Hooks, Rope Hooks Box 3 Hardware Card

Page 23

Assembly

23

Step 20 Install Cable Hooks

Parts:

•Rope Hooks (Box 3 Hardware Card)

Tools:

• 5/16” Allen Wrench

20-1Align the Hooks with the holes in the Main Frame with the tabs on the hooks inserted into the slots in the Main Frame.

20-2Install and completely tighten the hardware.

1/2” Nylock nut

NOTE: The remaining holes in the Main Frame just above the Hook Holes should be plugged with two 1/2” plugs from the Box 2 hardware card.

The remaining plugs are not needed on this unit and can be discarded.

Hook

Main Frame Plug these holes

1/2”x 4” Button Head Cap Screw

Hook

Hardware (1:1):

1 Button Head Cap Screw (1/2” X 4 ”)

Plug

1 Nylock Nut (1/2”)

Image 23

Contents Home Gym Before You Start Table of ContentsHardware Card Box Tools You Will NeedHardware Hardware Hardware Card Box Box 1 Contents Box ContentsBox 2 Contents Box 3 Contents Box 4 Contents Step Assembly UnboxingRubber Pads Box 3 hardware card Assemble Rear StabilizerInstall Rear Stabilizer Hardware Install Stabilizers and Lower Lat ConnectorStep Separate styrofoam Packing Lift box Styrofoam packing Remove Styrofoam Inner Packing AssemblyRemove Top Cover Install Tension Shaft Tighten Tension Shaft Holder Remove Cam Holders Install Pre-Tension SpiraFlex PacksReplace Top Cover Adjusting Cable TensionInstall Seat Support Plates Assembly Adjusting Cable TensionSeat Tube Cap Install Seat TubeRope Hooks Box 3 Hardware Card Install Cable HooksFigure a Install PulleysInstall Seat Pad Install Back PadAttaching Seat and Back Pad End Caps Box 4 Hardware Card Assemble Leg ExtensionFigure a Cable Install CablesApply Revolution XP Decal Final Inspection Important Contact Numbers For assistance