Bowflex 001-7057 manual Tighten Tension Shaft Holder

Page 18

18

Assembly

Step 13 Tighten Tension Shaft Holder

Tools:

• 7/32” Allen Wrench

13-1Use a 7/32” Allen Wrench to tighten the Tension Shaft Holder by tightening the screws in numerical order shown on the tensioner. Tighten the two screws marked 1, then the two marked 2, etc.

Note: Do not replace Top Cover at this time.

Tension screws

Tighten screws in order

1&1 , 2&2, 3&3, then

4&4.

Tension Shaft Holder

Image 18
Contents Home Gym Table of Contents Before You StartTools You Will Need Hardware Card BoxHardware Hardware Hardware Card Box Box Contents Box 1 ContentsBox 2 Contents Box 3 Contents Box 4 Contents Assembly Unboxing StepAssemble Rear Stabilizer Rubber Pads Box 3 hardware cardInstall Rear Stabilizer Install Stabilizers and Lower Lat Connector HardwareStep Separate styrofoam Packing Lift box Styrofoam packing Assembly Remove Top CoverRemove Styrofoam Inner Packing Install Tension Shaft Tighten Tension Shaft Holder Install Pre-Tension SpiraFlex Packs Remove Cam HoldersAdjusting Cable Tension Replace Top CoverAssembly Adjusting Cable Tension Install Seat Support PlatesInstall Seat Tube Seat Tube CapInstall Cable Hooks Rope Hooks Box 3 Hardware CardInstall Pulleys Figure aInstall Back Pad Install Seat PadAttaching Seat and Back Pad Assemble Leg Extension End Caps Box 4 Hardware CardInstall Cables Figure a CableApply Revolution XP Decal Final Inspection Important Contact Numbers For assistance