Gold's Gym GGSY3058.0 manual

Page 18

27.Route the Lat Cable (49) up through the Top Frame (4) and wrap the Cable over a Thin Pulley (24). Pull the M10 x 80mm Bolt (84) out of the Top Frame until it is flush with the first Thin Pulley from step 24. Do not remove the Bolt com- pletely from the Top Frame.

Hold the second Thin Pulley (24) inside the Top Frame (4) and attach it with the M10 x 80mm Bolt (84), a 19mm Spacer (67), an M10 Washer (80), and an M10 Nylon Locknut (77).

28.Wrap the Lat Cable (49) around a 90mm Pulley (48) and route the Cable down through the Top Frame (4). Attach the Pulley to the Top Frame with an M10 x 80mm Bolt (84), two M10 Washers (80), two 19mm Spacers (67), and an M10 Nylon Locknut (77).

29.Set an M12 Large Washer (98) on top of the Weight Selector (20). Thread the M12 Nut (112) all the way onto the Lat Cable (49).

Thread the Lat Cable (49) into the Weight Selector (20) two turns. Tighten the M12 Nut (112) against the M12 Large Washer (98).

27

24

 

 

 

 

 

 

49

 

80

 

84

 

 

 

 

 

113

 

 

 

4

67

 

 

 

77

28

84

 

67 48

 

80

 

 

 

 

 

67

 

 

 

80

 

49

 

77

 

4

 

 

29

 

 

 

 

 

 

49

 

 

 

112

 

 

 

98

 

 

 

20

18

Image 18
Contents QUESTIONS? Model No. GGSY3058.0 Serial NoCall TOLL-FREE Table of Contents Important Precautions Before YOU Begin Right SideLeft Side Part Identification Chart 21mm Steel Spacer 56.5mm Spacer 89.5mm SpacerPage Page Assembly Make Assembly EasierFour Stages of the Assembly Process Do not tighten the Nylon Locknuts yet Nylon Locknuts yetLocknuts yet Weight Selector is oriented as shown Repeat this step for the Right Shroud not shownTighten the Nylon Locknuts yet Repeat this step for the Right ShroudArm Assembly 100 103 118 Grease 109 106 105 Repeat this step for the Left Butterfly Arm Repeat this step for the Left Press Arm not shownBend Cable Assembly See . Tighten the M10 Nylon LocknutsPage Page Page Lever Cable 51 is under the Pulley Page Page Seat Assembly Repeat this step for the Left Butterfly PadKnob passes through one of the holes in the Backrest Frame Page Adjustment Changing the Weight SettingAttaching the Accessories Seat 32 can be adjusted in the same way Using the Curl PADAdjusting the Backrest Locking the Weight StackLocking the LEG Lever Weight Resistance ChartWeight High Butterfly Press ARM LEG Lever LOW Pulley LbsCable Diagram Butterfly CableLeg Lever Cable Maintenance Tightening the CablesExercise Guidelines Muscle Chart Cooling DownStaying Motivated Part LIST-Model No. GGSY3058.0 Qty Description7mm Spacer Grease Packet 112 M12 Nut Exploded Drawing A-Model No. GGSY3058.0 R0408A Exploded Drawing B-Model No. GGSY3058.0 Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT