2Wire AVIC-9DVD installation manual Connecting the power cord, Pink CAR Speed Signalinput

Connecting the System

Connecting the power cord (1)

Speed detection circuit lead

Car injection computer

Connector

Note: The position of the speed detection circuit depends on the car model. For details, consult the relevant documents from Pioneer.

When making connections for a model not listed in those documents or for which connection to the speed detection circuit is too difficult, connect the separately sold ND-PG1 speed pulse generator to the pink lead.

Note: The position of the parking brake switch depends on the car model. For details, consult the car owner’s manual or dealer.

Connection method

Clamp the parking brake switch power supply side lead.

Clamp firmly with needle-nosed pliers.

11

Connection method

Pass the extension cord and the lead for the speed detection circuit through this hole.

Clamp firmly with needle-nosed pliers.

Close the cover.

Pink (CAR SPEED SIGNALINPUT)

The navigation system is connected here to detect the distance the car travels. Always connect the car’s speed detection circuit or the ND-PG1 speed pulse generator, sold separately. Failure to make this connection will increase in the location display.

Lightgreen

Used to detect the ON/OFF status of the parking brake. This lead must be connected to the power supply side of the parking brake swich. If this connection is made incorrectly or omitted, certain functions of your navigation system will be unusable.

Power supply side

Ground side

Parking brake switch