2Wire AVIC-9DVD installation manual Installation

Page 15

Installation

CAUTION

Certain state laws may prohibit or restrict the placement and use of this sys- tem in your car. Please comply with all applicable laws and regulations regarding the use, installation, and operation of your navigation system.

Pioneer does not recommend that you install or service your DVD navigation unit yourself. Installing or servicing the product may expose you to risk of electric shock or other hazards. Refer all installation and servicing of your navigation unit to authorised Pioneer service personnel.

Never install the unit in places where:

*It could injure the driver or passengers if the car stops suddenly.

*It may interfere with the driver’s operation of the car, such as on the floor in front of the driver’s seat.

Make sure there is nothing behind the dashboard or panelling when drilling holes in them. Be careful not to damage fuel lines, brake lines or power cables.

When using screws, do not allow them to come into contact with any electri- cal lead. Vibration may damage wires, leading to a short circuit or other damage to the car.

To ensure proper installation, use the supplied parts in the manner specified. If any parts other than the supplied ones are used, they may damage internal parts of the unit or they may work loose and the unit may come off.

It is extremely dangerous to allow the GPS antenna lead or microphone lead to become wound around the steering column or shift lever. Be sure to install the unit in such a way that it will not obstruct driving.

Make sure that leads cannot get caught in a door or the sliding mechanism of a seat, resulting in a short circuit.

Please confirm the proper function of your car’s other equipment following installation of the DVD navigation unit.

ENGLISH ESPAÑOL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS

14

Image 15
Contents Installation Manual Important Information Contents Important Safeguards English Español Deutsch Français Italiano Nederlands Connecting the System Parts supplied Before installing the unitPower cord Connector To prevent damageConnecting the system To Pioneer Display RGB cable Supplied with the Display PurpleTo audio inputs To video input RCA cable sold separately To Video input Pink CAR Speed Signalinput Connecting the power cordEnglish Español Deutsch Fran Yellow Installation Before installing and fixing Before using the adhesive tapeTo guard against electromagnetic interference Installation notes Installing the main unitMain unit Deutsch Franç Fit mounting angles to the sides of the main unit Using tapping screwsFloor Tapping screw Fix to the floor with tapping screwsFastening the unit to the factory radio mounting bracket Installing the GPS antenna DashboardRoof Rear shelf GPS antenna Metal sheet Clamp 5 pcs When installing the antenna outside the car on the body When routing the lead in from the top of the doorWhen routing the lead in from inside the trunk Loading the batteries Installing the Remote controllerRemote controller handling notes Remote controller Alkaline battery HolderWhen attaching with elevated position When installing with double-sided tapeInstalling the microphone Microphone Microphone clipClamp When installing the microphone on the sun visor Install the microphone on the microphone clipInstall the microphone clip on the sun visor Install the microphone clip on the steering column When installing the microphone on the steering columnReset button After installing the unitReconnecting the battery Start the engine Press the reset button on the main unitInformation Importante Pour protéger le système de navigation Remarques sur l’installation Pièces fourniesTable des matières Branchement du système dans le cas d’unImportantes Mesures DE Securite English Français Deutsch Français Italiano Nederlands Branchement du système Position ACC Pas de position ACC Avant de raccorder l’appareilPour éviter des dégâts Pièces fourniesBranchement du système vers I’ecran Pioneer Câble RVB Fourni avec l’écran Vers les entrées audio Pourpre Entrée RVB PourpreSortie audio Sortie vidéo Branchment du systèmeÉcran muni de prises d’entrée Cinch RCA Côté alimentation Côté masse Contacteur de frein à main Branchement du cordon d’alimentationFermez le couvercle Le système de navigation est raccordé ici afin deCordon d’alimentation Noir, Orange/blanc, Rouge, Jaune Cf. Automatiquement atténué et le volume sonore est réduitCe produit à un autre produit, utilisez le manuel Chaque câbleJaune Installation Avant d’employer le ruban adhésif Avant un branchement définitifRemarques sur l’installation Installation de l’unité principaleVis taraudeuse Unité principaleLevier du sens d’installation Vis de verrouillage Sous l’unité de navigation DVDRouillage Installation Fixez l’unité sur le plancher avec les vis taraudeuses Vis taraudeuse PlancherDe diamètre ’appareil Planche de bord Toit Capot du coffre Lunette arrière Installation de l’antenne GPSAntenne GPS Plaque métallique Serre-fils 5 pièces Cheminement du fil par l’intérieur du coffre Cheminement du câble sur le haut de la portièreInsertion des piles Installation de la télécommandeRemarques sur le maniement de la télécommande Télécommande Pile alcaline SupportEn cas dinstallation avec bande adhêsive double face Boîtier de télécommandeRetirer Bande adhêsive double face large Installation du microphone Microphone Attache Installation du microphone sur le pare-soleilFixez le microphone sur l’attache fournie Fixez l’attache du microphone sur le pare-soleilInstallation du microphone sur la colonne de direction Fixez l’attache du microphone sur la colonne de directionBande adhésive double face Touche de réinitialisation Après installation de l’unitéConfigurez le système de navigation automobile Branchement de la batteriePioneer Corporation