Club Features
These next few pages provide information that lets you customize the cycle for your club. All these features remain hidden to the club patrons and can only be accessed using special key presses. Read this section if you want to:
•Change the display to a different language
•Change the display to U.S. Standard or Metric
•Set the maximum workout and pause times
•Set a
•Customize a program
•View the odometer
•Display the number of hours the cycle has been in use
•View the software versions and part numbers
•Check the error log
•Display the serial number
•Connect to CSAFE equipment
Club Programming Tips
•Electrical power must be supplied. A minimum pedal speed (20 revolutions per minute) must be maintained while programming the cycle. A constant power source is available if you use the optional power adapter. If you plan to program the cycle, purchasing the optional power adapter is highly recommended.
Note: If you do not use the optional power adapter during club programming mode, and the pedal speed falls below 20 RPM, no warning is given when the cycle moves into its
•The club programming mode is accessed by pressing the RESET key at the Precor banner. The remaining key presses must occur quickly and without pause. Always start at the Precor banner.
•The function of the QUICKSTART key is disabled while in club programming mode.
•The club programs appear sequentially. Pressing the ENTER key on the C846i or the SELECT on the C842i saves the changes you make and moves you through the programs. To exit a program without saving any changes, press the RESET key.
Product Owner’s Manual: Club Features | 8 |