Informational Displays (C846i)
The C846i cycle provides information about its use (odometer and hour meter), as well as software version, error log, and serial number. In general, you would only access this information if directed to do so by Precor Customer Support.
These instructions guide you through all five informational displays. Pressing the ENTER key moves you through the displays. To exit, press the RESET key at any time.
Viewing the Odometer
1.At the Precor banner, press the following keys in sequence and without pause:
RESET, 6, 5
Numbers appear on the display as you press the associated key.
The odometer value (the total revolutions) appears on the display followed by the word REVOLUTIONS.
2.When you are ready, press ENTER to move to the next display (hour meter).
Viewing the Hour Meter
HOUR METER appears followed by the number of hours that the unit has been in use. The cycle tracks the elapsed minutes, but the value that appears is truncated to the nearest full hour.
3.When you are ready, press ENTER to move to the next display (software version).
Viewing the Software Version and Part Numbers
SOFTWARE VERSION appears for two seconds. UPPER APP then appears followed by the upper board application software part number and version (for example,
4.To see the upper boot and lower boot application software version, use the arrow keys. If needed, you can move through all
5.Write the numbers below. You will need these numbers when you call Customer Support with
Upper Application P/N: ___________________
Upper Boot Software P/N: _____________
Lower Application P/N: ___________________
6.When you are ready, press ENTER to move to the next display (error log).
Product Owner’s Manual: Club Features | 15 |