Assembly Steps
Attach the right upright support to the base frame using four hex head bolts
(A) and four washers (B).
Lift the EFX, and then slide a wedge of packing material under the front of the unit.
Ask your assistant to hold the left upright support close to the base mounting bolts while you plug the cable connector into its receptacle. Push the cable connector into the left upright support.
Important: If the plastic grommet pops out of the base, replace it immediately. The grommet covers the metal edges so the cables are not cut or damaged.
Secure the left upright support using four washers (B) and four locknuts (C). Finger tighten.
Ask your assistant to grasp the upper display cable and remove any slack as you secure the upright support. Crimped or pinched cables are not covered by the Precor Limited Warranty.
4