Selecting a U.S. Standard or Metric Display
The EFX can display measurements in either U.S. Standard or Metric. (The default factory setting is set to display U.S. Standard.) To change this setting, perform the following steps:
1.At the scrolling Precor banner, press the following keys in sequence and without pause:
RESET, SELECT, RESISTANCE ▼, RESISTANCE ▲, CROSSRAMP ▲
Note: No CROSSRAMP keys exist on the EFX5.19. Use the RESISTANCE ▲ key on the left side of the keypad.
As shown in Diagram 10, numbers are associated with the keypad. The numbers 5, 6, 7, 1 appear on the display as you press the associated key.
EFX5.17i and EFX5.21i
1 |
| 6 | 7 |
2 | 4 |
| |
3 | 5 |
| |
|
| ||
EFX5.19 |
|
|
|
1 |
| 6 | 7 |
2 | 4 |
| |
3 | 5 |
| |
|
|
Diagram 10: Keypad programming numbers
2.SELECT UNITS scrolls across the display, and then the current unit of measure appears. Use an arrow key to switch between the options.
3.Press SELECT to accept the displayed setting.
The change will be retained in memory even if the EFX is turned OFF and unplugged.
4.Press RESET to return to the Precor banner.
Owner’s Manual: Advanced Programming and Troubleshooting | 34 |