Photo 1
Install handrail/ display assembly.
Handrail/display assembly
Handrail/display assembly mount
| 4. Position the handrail assembly so both the right and left handrail columns | |
| align over the mounts. (See Photo 1.) Replace the washers and locknuts. | |
| Using the 1/2" box end wrench, begin to tighten each locknut. Alternate | |
| between each one until all four locknuts are snug up against the handrail | |
| columns. | |
|
|
|
Photo 2 | Install ribbon |
|
| ||
| cable connector. | |
Printed circuit board
Ribbon cable connector receptacle
Ribbon cable connector
Handrail/display assembly
5.Locate the ribbon cable connector that protrudes from the handrail/display assembly.
6.Align the tab on the side of the ribbon cable connector with its correspond- ing receptacle on the printed circuit board located near the motor. (See Photo 2.) Make sure that all pins are aligned and fully engaged. The connector is designed to engage in one direction only. Do not force the connector into the receptacle.
page 8