ProForm PFTL20511.0 user manual

Page 11

7.Attach the Left Handrail (88) to the Left Upright (89) with two 5/16" x 1" Screws (5), two 5/16" Star Washers (11), and a 5/16" x 1 1/4" Bolt (4).

Do not tighten the Screws and Bolt yet.

Attach the Right Handrail (87) in the same way.

8.Set the console assembly face down on a soft surface to avoid scratching the console assembly.

Remove all of the screws (B) attaching the Crossbar (93). Next, lift off the Crossbar. Discard the Screws.

9.IMPORTANT: To avoid damaging the Crossbar (93), do not use power tools and do not overtighten the #10 x 3/4" Screws (9) or the #10 x 3/4" Flat Head Screws (112).

Orient the Crossbar (93) as shown. Attach the Crossbar to the Handrails (87, 88) with two #10 x 3/4" Flat Head Screws (112), two #10 x 3/4" Screws (9), and two 1/4" Star Washers (35) as shown. Start all four Screws, and then tighten them.

7

 

4 11

 

 

 

87

11

5

5

 

 

 

4

 

88

 

 

 

 

89

 

 

 

8

 

Console

 

 

 

 

Assembly

 

B

 

 

93

 

9

9

112

 

 

93

35

 

87

9

112

 

35

 

 

 

88

 

11

Image 11
Contents Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT QUESTIONS?Model No. PFTL20511.0 Serial No Call TOLL-FREETable of Contents Important Precautions Page Power Lines Before YOU Begin Part Identification Chart Make sure that the power cord is unplugged AssemblyAttach the Right Upright not shown See the inset drawing. Tie the wire tieBe careful not to pinch the Upright Wire Tighten the Screws yet. Note It may be helpBase Covers into place yet Page Again. if YOU do not Connect the CON Wire. See the inset drawing. The connectorsCable from the console assembly Should slide together easily and snap intoPage Make sure that the caps remain in the ends Storage Latch Screws before tightening them TV Assembly Chest Heart Rate Monitor HOW to PUT on the Heart Rate MonitorCare and Maintenance TroubleshootingUse a Surge Suppressor HOW to Connect the TreadmillHOW to Connect the Power Cord Ohm Catv Cable HOW to Connect AN AntennaOhm Flat Wire HOW to Connect AN External Source Using a Catv CableHdmi Console Operation and AdjustmentDiagram Features of the ConsoleHOW to USE the Touch Screen HOW to Turn on the PowerCreate an iFit Live account HOW to SET UP the ConsoleConnect to your wireless network Check for firmware updates Calibrate the incline systemHOW to USE the Manual Mode This, the treadmill’s electrical components may When you are finished exercising, removePower cord. Important If you do not do Key from the consoleStart the workout HOW to USE AN Onboard WorkoutSelect an onboard workout Select the main menu. See on Select a set-a-goal workout HOW to USE a SET-A-GOAL WorkoutStart the workout. See on HOW to USE AN Ifit Live WorkoutHOW to USE the Equipment Settings Mode Find keycodes HOW to USE the Maintenance ModeExit the maintenance mode Exit the wireless network mode HOW to USE the Wireless Network ModeEnable Wi-Fi Set up and manage a wireless network connectionHOW to USE the Internet Browser HOW to USE the Stereo Sound SystemHOW to USE the Entertainment Mode HOW to Operate the 15 Digital TVHOW to Replace the Batteries in the Remote Control HOW to USE the Remote ControlAdjust the channel settings HOW to Adjust the Television SettingsAdjust the image settings Adjust the audio settingsExit the menu Adjust the parental control settingsSet up the basic television settings Adjust the advanced television settingsHOW to Lower the Treadmill for USE HOW to Fold and Move the TreadmillHOW to Fold the Treadmill HOW to Move the TreadmillSymptom The power turns off during use TroubleshootingTop View Symptom The walking belt slows when walked onSymptom The television is not receiving a signal Symptom The volume cannot be turned up Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesKey No. Qty Description Part ListExploded Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Icon Health & Fitness, Inc., 1500 S W., Logan, UT Ordering Replacement PartsLimited Warranty