ProForm PFTL20511.0 user manual HOW to Connect the Treadmill, HOW to Connect the Power Cord

Page 18

HOW TO CONNECT THE TREADMILL

HOW TO CONNECT THE POWER CORD

Use a Surge Suppressor

Your treadmill, like other electronic equipment, can be damaged by sudden voltage changes in your home’s power. Voltage surges, spikes, and noise interfer- ence can result from weather conditions or from other appliances being turned on or off. To decrease the risk of damaging the treadmill, always use a surge suppressor with the treadmill. To purchase a surge suppressor, see precaution 12 on page 3.

Use only a surge suppressor that is UL 1449 listed as a transient voltage surge suppressor (TVSS). The surge suppressor must have a UL suppressed voltage rating of 400 volts or less and a minimum surge dissipation of 450 joules. The surge suppressor must also be electri- cally rated for 120 volts AC and 15 amps. There must be a monitoring light on the surge suppressor to indi- cate whether it is functioning properly. Failure to use a properly functioning surge suppressor could result in damage to the control system of the treadmill and serious injury to users.

Plug in the Power Cord

nominal 120-volt circuit capable of carrying 15 or more amps. To avoid overloading the circuit, do not plug other electrical devices, except for low- power devices such as cell phone chargers, into the surge suppressor or into an outlet on the same circuit. IMPORTANT: The treadmill is not compat- ible with GFCI-equipped outlets and may not be compatible with AFCI-equipped outlets.

1

Grounded Outlet

Grounding Pin

Grounding Pin

Surge

Suppressor

The treadmill must be grounded. If it should malfunc- tion or break down, grounding provides a path of least resistance for electric current to reduce the risk of elec- tric shock. The treadmill power cord has a plug with a grounding pin (see drawing 1 on this page).

DANGER: Improper connection of the power cord increases the risk of elec- tric shock. Do not modify the plug—if it will not fit an outlet, have a proper outlet installed by a qualified electrician. If you are unsure

Atemporary adapter may be used to connect the surge sup- pressor to a 2-pole receptacle if a properly grounded outlet is not available.

2

2-pole Receptacle

Adapter

Lug

Metal

Screw

whether the treadmill is properly grounded, contact a qualified electrician.

Plug the power cord into a surge suppressor, and plug the surge suppressor into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. The outlet must be on a

The lug or wire extending from the adapter must be connected with a metal screw to a permanent ground such as a properly grounded outlet box cover.

Some 2-pole receptacle outlet box covers are not grounded. Before using an adapter, contact a quali- fied electrician to determine whether the outlet box cover is grounded. The temporary adapter should be used only until a properly grounded outlet can be installed by a qualified electrician.

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Call TOLL-FREE QUESTIONS?Model No. PFTL20511.0 Serial No Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MTTable of Contents Important Precautions Page Power Lines Before YOU Begin Part Identification Chart Assembly Make sure that the power cord is unpluggedTighten the Screws yet. Note It may be help See the inset drawing. Tie the wire tieBe careful not to pinch the Upright Wire Attach the Right Upright not shownBase Covers into place yet Page Should slide together easily and snap into Wire. See the inset drawing. The connectorsCable from the console assembly Again. if YOU do not Connect the CONPage Make sure that the caps remain in the ends Storage Latch Screws before tightening them TV Assembly Troubleshooting HOW to PUT on the Heart Rate MonitorCare and Maintenance Chest Heart Rate MonitorHOW to Connect the Treadmill HOW to Connect the Power CordUse a Surge Suppressor HOW to Connect AN External Source Using a Catv Cable HOW to Connect AN AntennaOhm Flat Wire Ohm Catv CableHdmi Features of the Console Operation and AdjustmentDiagram ConsoleHOW to Turn on the Power HOW to USE the Touch ScreenCalibrate the incline system HOW to SET UP the ConsoleConnect to your wireless network Check for firmware updates Create an iFit Live accountHOW to USE the Manual Mode Key from the console When you are finished exercising, removePower cord. Important If you do not do This, the treadmill’s electrical components mayHOW to USE AN Onboard Workout Select an onboard workoutStart the workout HOW to USE a SET-A-GOAL Workout Select the main menu. See on Select a set-a-goal workoutHOW to USE AN Ifit Live Workout Start the workout. See onHOW to USE the Equipment Settings Mode HOW to USE the Maintenance Mode Exit the maintenance modeFind keycodes Set up and manage a wireless network connection HOW to USE the Wireless Network ModeEnable Wi-Fi Exit the wireless network modeHOW to USE the Stereo Sound System HOW to USE the Internet BrowserHOW to Operate the 15 Digital TV HOW to USE the Entertainment ModeHOW to USE the Remote Control HOW to Replace the Batteries in the Remote ControlAdjust the audio settings HOW to Adjust the Television SettingsAdjust the image settings Adjust the channel settingsAdjust the advanced television settings Adjust the parental control settingsSet up the basic television settings Exit the menuHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill HOW to Lower the Treadmill for USETroubleshooting Symptom The power turns off during useSymptom The walking belt slows when walked on Top ViewSymptom The television is not receiving a signal Symptom The volume cannot be turned up Workout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencyPart List Key No. Qty DescriptionExploded Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Ordering Replacement Parts Limited WarrantyIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Top Page Image Contents