ProForm PFTL20511.0 user manual Symptom The television is not receiving a signal

Page 40

SYMPTOM: The walking belt is off-center or slips when walked on

a.If the walking belt is off-center, first remove the key and UNPLUG THE POWER CORD. If the walking belt has shifted to the left, use the hex key to turn the left idler roller screw clockwise 1/2 of a turn; if the walking belt has shifted to the right, turn the left idler roller screw counterclock- wise 1/2 of a turn. Be careful not to overtighten the walking belt. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is centered.

a

b.If the walking belt slips when walked on, first remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both idler roller screws clockwise, 1/4 of a turn. When the walk- ing belt is correctly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and carefully walk on the treadmill for a few minutes. Repeat until the walk- ing belt is properly tightened.

b

SYMPTOM: The iFit Live mode does not function correctly

a.If the iFit Live mode is not functioning correctly, make sure that the treadmill has the most current firmware available (see step 3 on page 30).

SYMPTOM: The treadmill will not connect to the wireless network

a.Make sure that the wireless settings on your con- sole are correct (see step 4 on page 31).

b.Make sure that the settings for your wireless net- work are correct.

c.If you still have questions, see the front cover of this manual.

SYMPTOM: The television is not receiving a signal

a. Make sure that the correct TV or AV source is selected. See step 2 on page 33 to select a televi- sion source.

b.Make sure that the antenna cable, CATV cable, AV cable, or HDMI cable is connected securely to the treadmill or the 15" digital TV. See page 19 to connect a CATV cable to the treadmill or page 20 to connect an AV cable or HDMI cable to the TV.

c.Scan for broadcast or cable signals. See step 4 on page 35 to scan for signals.

d.Due to an FCC requirement, analog signals are no longer broadcast over the air in the United States as of June 12, 2009. If you wish to view television signals through an antenna, you must have an antenna capable of receiving digital signals. Cable television has not been affected.

40

Image 40
Contents QUESTIONS? Model No. PFTL20511.0 Serial NoCall TOLL-FREE Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MTTable of Contents Important Precautions Page Power Lines Before YOU Begin Part Identification Chart Assembly Make sure that the power cord is unpluggedSee the inset drawing. Tie the wire tie Be careful not to pinch the Upright WireTighten the Screws yet. Note It may be help Attach the Right Upright not shownBase Covers into place yet Page Wire. See the inset drawing. The connectors Cable from the console assemblyShould slide together easily and snap into Again. if YOU do not Connect the CONPage Make sure that the caps remain in the ends Storage Latch Screws before tightening them TV Assembly HOW to PUT on the Heart Rate Monitor Care and MaintenanceTroubleshooting Chest Heart Rate MonitorHOW to Connect the Power Cord HOW to Connect the TreadmillUse a Surge Suppressor HOW to Connect AN Antenna Ohm Flat WireHOW to Connect AN External Source Using a Catv Cable Ohm Catv CableHdmi Operation and Adjustment DiagramFeatures of the Console ConsoleHOW to Turn on the Power HOW to USE the Touch ScreenHOW to SET UP the Console Connect to your wireless network Check for firmware updatesCalibrate the incline system Create an iFit Live accountHOW to USE the Manual Mode When you are finished exercising, remove Power cord. Important If you do not doKey from the console This, the treadmill’s electrical components maySelect an onboard workout HOW to USE AN Onboard WorkoutStart the workout HOW to USE a SET-A-GOAL Workout Select the main menu. See on Select a set-a-goal workoutHOW to USE AN Ifit Live Workout Start the workout. See onHOW to USE the Equipment Settings Mode Exit the maintenance mode HOW to USE the Maintenance ModeFind keycodes HOW to USE the Wireless Network Mode Enable Wi-FiSet up and manage a wireless network connection Exit the wireless network modeHOW to USE the Stereo Sound System HOW to USE the Internet BrowserHOW to Operate the 15 Digital TV HOW to USE the Entertainment ModeHOW to USE the Remote Control HOW to Replace the Batteries in the Remote ControlHOW to Adjust the Television Settings Adjust the image settingsAdjust the audio settings Adjust the channel settingsAdjust the parental control settings Set up the basic television settingsAdjust the advanced television settings Exit the menuHOW to Fold and Move the Treadmill HOW to Fold the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USETroubleshooting Symptom The power turns off during useSymptom The walking belt slows when walked on Top ViewSymptom The television is not receiving a signal Symptom The volume cannot be turned up Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart List Key No. Qty DescriptionExploded Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT