ProForm PFTL20511.0 Wire. See the inset drawing. The connectors, Cable from the console assembly

10. With the help of a second person, hold the con-	10
sole assembly near the Left Handrail (88).
Connect the Upright Wire (81) to the console		Console
wire. See the inset drawing. The connectors		Assembly
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER. Remove the wire tie from the		Console
Upright Wire.
Connect the Upright Coaxial Cable (not	Coaxial Cables Wire
		81
shown) in the Right Upright (not shown) to	Console
the cable from the console assembly.	Wire

				Wire
	81			Tie		88
11. Set the console assembly on the Right Handrail	11
(87) and the Left Handrail (88). Be careful not					Console
to pinch any wires. Insert the excess wires (not
					Assembly
shown) into the Handrails.
Attach the console assembly with six #8 x 1/2"
Screws (1) and four 1/4" x 1/2" Screws (36) with
four 5/16" Flat Washers (113) and four 1/4" Star			87			88
Washers (35) as shown. Start all ten Screws,	35				35
and then tighten them.	113					113
See step 7. Tighten the four 5/16" x 1" Screws
	36					36
(5) and the two 5/16" x 1 1/4" Bolts (4).		1	1	1	1
12. Tighten the four 3/8" x 2 3/4" Screws (7) first and	12
then the four 3/8" x 1 1/4" Screws (8) (only one
side is shown).
	7
		8	94
	12