ProForm PFTL20511.0 user manual Symptom The volume cannot be turned up

Page 41

SYMPTOM: The volume cannot be turned up

a.If there is no sound coming from the television, make sure that the television audio is not muted.

b.If there is no sound coming from the television, make sure that the audio wire is not plugged into the audio jack on the console.

SYMPTOM: The television needs to be cleaned

a.UNPLUG THE POWER CORD. To clean the televi- sion, wipe the television and screen using a soft cloth with a small amount of soft detergent. Do not use a polishing cloth, solvent, or any type of propellant or chemical detergent such as alcohol or benzene.

SYMPTOM: Television reception is poor

a.Make sure that the television settings are set cor- rectly. See HOW TO ADJUST THE TELEVISION SETTINGS on page 35.

b.For the television to operate properly, good recep- tion is necessary. If you are using an antenna, make sure that it is properly connected and adjusted for optimal reception. (See HOW TO CONNECT AN ANTENNA on page 19.)

c.Check for the problems listed at the right and follow the applicable instructions.

•Ignition (black spots or horizontal streaks that appear or a picture that flutters or drifts)—Usually this is caused by interference from automobile igni- tion systems, neon lamps, electric drifts, or other electric appliances. Try changing the position of the treadmill or other electric appliances to correct the problem.

•Ghosts—Ghosts are caused by the television signal following two paths—one is the direct path and the other is reflected from tall buildings, hills, or other objects. Change the direction or position of the antenna to improve reception.

•Blue Screen—If the treadmill is located in the fringe area of a television station where the signal is weak, the picture may be of poor quality or a blue screen may appear. If the signal is weak, it may be necessary to install an external antenna to improve the picture.

•Fading—If blocks of the picture are missing, the picture moves around the screen, or the picture disappears, the signal may be weak. Change the direction or position of the antenna to improve reception. Make sure the television settings are set correctly (see HOW TO ADJUST TELEVISION SETTINGS on page 35). Do not use a splitter.

Note: If one of these problems appears when the cable from a CATV company is connected, the problem may be caused by the cable company broadcast.

41

Image 41

Contents Model No. PFTL20511.0 Serial No QUESTIONS?Call TOLL-FREE Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MTTable of Contents Important Precautions Page Power Lines Before YOU Begin Part Identification Chart Make sure that the power cord is unplugged AssemblyBe careful not to pinch the Upright Wire See the inset drawing. Tie the wire tieTighten the Screws yet. Note It may be help Attach the Right Upright not shownBase Covers into place yet Page Cable from the console assembly Wire. See the inset drawing. The connectorsShould slide together easily and snap into Again. if YOU do not Connect the CONPage Make sure that the caps remain in the ends Storage Latch Screws before tightening them TV Assembly Care and Maintenance HOW to PUT on the Heart Rate MonitorTroubleshooting Chest Heart Rate MonitorUse a Surge Suppressor HOW to Connect the TreadmillHOW to Connect the Power Cord Ohm Flat Wire HOW to Connect AN AntennaHOW to Connect AN External Source Using a Catv Cable Ohm Catv CableHdmi Diagram Operation and AdjustmentFeatures of the Console ConsoleHOW to USE the Touch Screen HOW to Turn on the PowerConnect to your wireless network Check for firmware updates HOW to SET UP the ConsoleCalibrate the incline system Create an iFit Live accountHOW to USE the Manual Mode Power cord. Important If you do not do When you are finished exercising, removeKey from the console This, the treadmill’s electrical components mayStart the workout HOW to USE AN Onboard WorkoutSelect an onboard workout Select the main menu. See on Select a set-a-goal workout HOW to USE a SET-A-GOAL WorkoutStart the workout. See on HOW to USE AN Ifit Live WorkoutHOW to USE the Equipment Settings Mode Find keycodes HOW to USE the Maintenance ModeExit the maintenance mode Enable Wi-Fi HOW to USE the Wireless Network ModeSet up and manage a wireless network connection Exit the wireless network modeHOW to USE the Internet Browser HOW to USE the Stereo Sound SystemHOW to USE the Entertainment Mode HOW to Operate the 15 Digital TVHOW to Replace the Batteries in the Remote Control HOW to USE the Remote ControlAdjust the image settings HOW to Adjust the Television SettingsAdjust the audio settings Adjust the channel settingsSet up the basic television settings Adjust the parental control settingsAdjust the advanced television settings Exit the menuHOW to Fold the Treadmill HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USESymptom The power turns off during use TroubleshootingTop View Symptom The walking belt slows when walked onSymptom The television is not receiving a signal Symptom The volume cannot be turned up Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencyKey No. Qty Description Part ListExploded Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Icon Health & Fitness, Inc., 1500 S W., Logan, UT Ordering Replacement PartsLimited Warranty