ProForm PFTL20511.0 user manual TV Assembly

Page 16

21.With the help of a second person, hold the TV assembly near the console assembly, and con- nect the wires.

Attach the TV assembly to the back of the con- sole assembly with four 1/4" x 3/4" Screws (116).

Be careful not to pinch any wires. Start all four Screws, and then tighten them.

21	TV Assembly
	TV Assembly
	Console
	Assembly
	Wires
	116

22.Place the treadmill near the coaxial cable from your wall (or device). Connect the coaxial cable to the Upright Coaxial Cable (122).

Press the Right Base Cover (83) and the Left Base Cover (not shown) onto the Base (94) until they snap into place.

22

83

94

122

23.Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill.

Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see pages 39 and 40).

16

Image 16

Contents QUESTIONS? Model No. PFTL20511.0 Serial NoCall TOLL-FREE Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MTTable of Contents Important Precautions Page Power Lines Before YOU Begin Part Identification Chart Assembly Make sure that the power cord is unpluggedSee the inset drawing. Tie the wire tie Be careful not to pinch the Upright WireTighten the Screws yet. Note It may be help Attach the Right Upright not shownBase Covers into place yet Page Wire. See the inset drawing. The connectors Cable from the console assemblyShould slide together easily and snap into Again. if YOU do not Connect the CONPage Make sure that the caps remain in the ends Storage Latch Screws before tightening them TV Assembly HOW to PUT on the Heart Rate Monitor Care and MaintenanceTroubleshooting Chest Heart Rate MonitorHOW to Connect the Power Cord HOW to Connect the TreadmillUse a Surge Suppressor HOW to Connect AN Antenna Ohm Flat WireHOW to Connect AN External Source Using a Catv Cable Ohm Catv CableHdmi Operation and Adjustment DiagramFeatures of the Console ConsoleHOW to Turn on the Power HOW to USE the Touch ScreenHOW to SET UP the Console Connect to your wireless network Check for firmware updatesCalibrate the incline system Create an iFit Live accountHOW to USE the Manual Mode When you are finished exercising, remove Power cord. Important If you do not doKey from the console This, the treadmill’s electrical components maySelect an onboard workout HOW to USE AN Onboard WorkoutStart the workout HOW to USE a SET-A-GOAL Workout Select the main menu. See on Select a set-a-goal workoutHOW to USE AN Ifit Live Workout Start the workout. See onHOW to USE the Equipment Settings Mode Exit the maintenance mode HOW to USE the Maintenance ModeFind keycodes HOW to USE the Wireless Network Mode Enable Wi-FiSet up and manage a wireless network connection Exit the wireless network modeHOW to USE the Stereo Sound System HOW to USE the Internet BrowserHOW to Operate the 15 Digital TV HOW to USE the Entertainment ModeHOW to USE the Remote Control HOW to Replace the Batteries in the Remote ControlHOW to Adjust the Television Settings Adjust the image settingsAdjust the audio settings Adjust the channel settingsAdjust the parental control settings Set up the basic television settingsAdjust the advanced television settings Exit the menuHOW to Fold and Move the Treadmill HOW to Fold the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USETroubleshooting Symptom The power turns off during useSymptom The walking belt slows when walked on Top ViewSymptom The television is not receiving a signal Symptom The volume cannot be turned up Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart List Key No. Qty DescriptionExploded Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT