ProForm PFTL20511.0 user manual HOW to Connect AN Antenna, Ohm Catv Cable, Ohm Flat Wire

Page 19

Before operating the 15" digital TV, you must connect an antenna or a 75 ohm CATV cable to the 75 ohm terminal, an AV cable to the audio/video input jack, or an HDMI cable to the HDMI input jack. Note: Use a CATV cable to connect to an external source such as a cable box, satellite TV box, VCR, or analog cable. No CATV cable, antenna, or adapter; AV cable; or HDMI cable is included.

HOW TO CONNECT AN ANTENNA

2. Push the 300 ohm

to 75 ohm adapter

300 to 75 Ohm Adapter

Place an indoor VHF antenna or an outdoor combination VHF/UHF antenna in the desired location. Outdoor antennas are subject to weather- ing that can reduce signal quality. Inspect your out- door antenna and the lead-in wiring before connecting the antenna.

75 Ohm CATV Cable

1.Connect the 75 ohm CATV cable from the antenna to the 75 ohm terminal on the treadmill frame near the power cord.

300 Ohm Flat Wire

1.Connect the 300 ohm flat wire from the antenna to a 300 ohm to 75 ohm adapter.

 

 

 

 

 

 

 

 

 

 

Outdoor

 

Indoor

 

 

 

 

VHF

Combination

 

Antenna

 

VHF/UHF

 

 

 

 

 

Antenna

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

75 Ohm CATV Cable

75 Ohm Terminal

Screwdriver

300

Ohm Flat

Wire

300 to 75 Ohm Adapter

onto the 75 ohm

terminal on the

treadmill frame near

the power cord.

75 Ohm

Terminal

Note: Due to an FCC requirement, analog signals are no longer broadcast over the air in the United States as of June 12, 2009. If you wish to view television signals through an antenna, you must have an antenna capable of receiving digital signals. Cable television has not been affected.

HOW TO CONNECT AN EXTERNAL SOURCE USING A CATV CABLE

1.Connect one end of a 75 ohm CATV cable to the 75 ohm output jack on your external source.

2.Plug in the power cord of your external source. See your external source’s user’s manual for proper grounding instructions.

3.Connect the 75 ohm CATV cable to the 75 ohm ter- minal on the treadmill frame near the power cord. See the drawing at the left.

19

Image 19
Contents Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT QUESTIONS?Model No. PFTL20511.0 Serial No Call TOLL-FREETable of Contents Important Precautions Page Power Lines Before YOU Begin Part Identification Chart Make sure that the power cord is unplugged AssemblyAttach the Right Upright not shown See the inset drawing. Tie the wire tieBe careful not to pinch the Upright Wire Tighten the Screws yet. Note It may be helpBase Covers into place yet Page Again. if YOU do not Connect the CON Wire. See the inset drawing. The connectorsCable from the console assembly Should slide together easily and snap intoPage Make sure that the caps remain in the ends Storage Latch Screws before tightening them TV Assembly Chest Heart Rate Monitor HOW to PUT on the Heart Rate MonitorCare and Maintenance TroubleshootingHOW to Connect the Power Cord HOW to Connect the TreadmillUse a Surge Suppressor Ohm Catv Cable HOW to Connect AN AntennaOhm Flat Wire HOW to Connect AN External Source Using a Catv CableHdmi Console Operation and AdjustmentDiagram Features of the ConsoleHOW to USE the Touch Screen HOW to Turn on the PowerCreate an iFit Live account HOW to SET UP the ConsoleConnect to your wireless network Check for firmware updates Calibrate the incline systemHOW to USE the Manual Mode This, the treadmill’s electrical components may When you are finished exercising, removePower cord. Important If you do not do Key from the consoleSelect an onboard workout HOW to USE AN Onboard WorkoutStart the workout Select the main menu. See on Select a set-a-goal workout HOW to USE a SET-A-GOAL WorkoutStart the workout. See on HOW to USE AN Ifit Live WorkoutHOW to USE the Equipment Settings Mode Exit the maintenance mode HOW to USE the Maintenance ModeFind keycodes Exit the wireless network mode HOW to USE the Wireless Network ModeEnable Wi-Fi Set up and manage a wireless network connectionHOW to USE the Internet Browser HOW to USE the Stereo Sound SystemHOW to USE the Entertainment Mode HOW to Operate the 15 Digital TVHOW to Replace the Batteries in the Remote Control HOW to USE the Remote ControlAdjust the channel settings HOW to Adjust the Television SettingsAdjust the image settings Adjust the audio settingsExit the menu Adjust the parental control settingsSet up the basic television settings Adjust the advanced television settingsHOW to Lower the Treadmill for USE HOW to Fold and Move the TreadmillHOW to Fold the Treadmill HOW to Move the TreadmillSymptom The power turns off during use TroubleshootingTop View Symptom The walking belt slows when walked onSymptom The television is not receiving a signal Symptom The volume cannot be turned up Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesKey No. Qty Description Part ListExploded Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT