ProForm PFTL20511.0 user manual HOW to USE the Remote Control

Page 34

HOW TO USE THE REMOTE CONTROL

The first time you use the remote control, insert batteries (see HOW TO REPLACE THE BATTERIES IN THE REMOTE CONTROL at the right).

Next, stand on the treadmill and hold the remote control near the television. Point the remote control directly at the television.

Press the Power button (). After a few moments, the television will turn on or turn off.

Press the volume (Vol) increase or decrease button to adjust the TV volume.

Press the Mute button to turn on or turn off the sound.

Press the numbered channel buttons and the dash button (–) or the Channel (CH) increase or decrease button to select a channel.

Press the return button () to view the previous channel.

Press the Menu button to view the main menu or to view a previous menu. See pages 35 and 36 for infor- mation about the menu.

Press the arrow keys to navigate in the menu. Press the OK/Enter button to make a selection in the menu.

Press the Exit button to exit any menu.

Press the List button to view a list of channels. If you have labeled any channels, the menu will also show the channel label. See page 35 for information about labeling channels.

Press the EPG button to view the electronic program guide. Note: The electronic program guide is only avail- able when viewing ATSC digital television.

Press the Display button to view information about the current program and the broadcast or cable signal.

Press the CC button repeatedly to turn on or turn off closed captioning. See step 6 on page 36 to adjust closed captioning settings.

Press the Source button repeatedly to select the input source. Select TV for cable or antenna input, AV for a device connected to the TV with an AV cable, or HDMI for a device connected with an HDMI cable.

Press the MTS button repeatedly to select English or Spanish as the audio setting language.

Press the Aspect button repeatedly to select normal, wide, cinema, or zoom image as the display format.

Press the V-Chip button to adjust parental control settings.

Press the Fav button to select the Favorite List of channels. See step 4 on page 35 to create a favorite channels list.

HOW TO REPLACE THE BATTERIES IN THE REMOTE CONTROL

To replace the batteries, first locate the battery cover on the back of the remote control. Push down on the clip on the battery cover and pull off the battery cover.

Next, remove the old batteries from the remote control, and insert two new AAA batteries. Make sure to insert the batteries as shown in the drawing. Then, press the battery cover onto the remote control.

34

Page 33 Page 35
Image 34
Page 33 Page 35
Contents Call TOLL-FREE QUESTIONS?Model No. PFTL20511.0 Serial No Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MTTable of Contents Important Precautions Page Power Lines Before YOU Begin Part Identification Chart Assembly Make sure that the power cord is unpluggedTighten the Screws yet. Note It may be help See the inset drawing. Tie the wire tieBe careful not to pinch the Upright Wire Attach the Right Upright not shownBase Covers into place yet Page Should slide together easily and snap into Wire. See the inset drawing. The connectorsCable from the console assembly Again. if YOU do not Connect the CONPage Make sure that the caps remain in the ends Storage Latch Screws before tightening them TV Assembly Troubleshooting HOW to PUT on the Heart Rate MonitorCare and Maintenance Chest Heart Rate MonitorHOW to Connect the Power Cord HOW to Connect the TreadmillUse a Surge Suppressor HOW to Connect AN External Source Using a Catv Cable HOW to Connect AN AntennaOhm Flat Wire Ohm Catv CableHdmi Features of the Console Operation and AdjustmentDiagram ConsoleHOW to Turn on the Power HOW to USE the Touch ScreenCalibrate the incline system HOW to SET UP the ConsoleConnect to your wireless network Check for firmware updates Create an iFit Live accountHOW to USE the Manual Mode Key from the console When you are finished exercising, removePower cord. Important If you do not do This, the treadmill’s electrical components maySelect an onboard workout HOW to USE AN Onboard WorkoutStart the workout HOW to USE a SET-A-GOAL Workout Select the main menu. See on Select a set-a-goal workoutHOW to USE AN Ifit Live Workout Start the workout. See onHOW to USE the Equipment Settings Mode Exit the maintenance mode HOW to USE the Maintenance ModeFind keycodes Set up and manage a wireless network connection HOW to USE the Wireless Network ModeEnable Wi-Fi Exit the wireless network modeHOW to USE the Stereo Sound System HOW to USE the Internet BrowserHOW to Operate the 15 Digital TV HOW to USE the Entertainment ModeHOW to USE the Remote Control HOW to Replace the Batteries in the Remote ControlAdjust the audio settings HOW to Adjust the Television SettingsAdjust the image settings Adjust the channel settingsAdjust the advanced television settings Adjust the parental control settingsSet up the basic television settings Exit the menuHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill HOW to Lower the Treadmill for USETroubleshooting Symptom The power turns off during useSymptom The walking belt slows when walked on Top ViewSymptom The television is not receiving a signal Symptom The volume cannot be turned up Workout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencyPart List Key No. Qty DescriptionExploded Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Top Page Image Contents