ProForm PFTL20511.0 See the inset drawing. Tie the wire tie, Attach the Right Upright not shown

3. Identify the Left Upright (89), which is marked	3
with a “Left” sticker or an “L” sticker. Have a sec-
ond person hold the Left Upright near the			81
Base (94).
				89
See the inset drawing. Tie the wire tie in the
				Wire	81
Left Upright (89) securely around the end of the
Upright Wire (81). Then, pull the other end of the				Tie
wire tie until the Upright Wire is routed through			Wire
the Left Upright.
			Tie
	89
			81	94
4. Hold the Left Upright (89) against the Base (94).	4
Be careful not to pinch the Upright Wire (81).
Insert two 3/8" x 1 1/4" Screws (8) with two 3/8"				81
Star Washers (13) and two 3/8" x 2 3/4" Screws
(7) into the Left Upright.		89
Partially tighten the 3/8" x 2 3/4" Screws (7) and
the 3/8" x 1 1/4" Screws (8) until the heads of the
Screws touch the Left Upright (89); do not fully
tighten the Screws yet. Note: It may be help-
ful to use the Short Hex Key (64) on the Screw
shown.	7
Attach the Right Upright (not shown) in the			64
same way. Note: There is a coaxial cable in the
Right Upright.
	13
	8	13	94
	9