ProForm PFTL20511.0 user manual Screws before tightening them

Page 15

18. Attach the Rear Feet (57) to the Frame (56) as

18

 

shown with four #8 x 3/4" Screws (2).

 

 

 

Lower the Frame (56) (see HOW TO LOWER

 

 

THE TREADMILL FOR USE on page 37).

57

 

 

57

 

 

 

2

2

 

 

 

56

 

19. Press the Grommet (77) into the square hole in

19

 

the Base (94).

 

 

 

 

 

94

 

 

77

20. Remove the #8 x 1/2" Machine Screw (114) and

20

 

the Wire Cover (117) from the TV Bracket (118).

115

 

With the helpf of a second person, hold the TV

 

 

(119) near the TV Bracket (118) and insert the

 

 

wires from the TV down through the indicated

 

115

Cable Tie (99).

 

119

 

Attach the TV (119) to the TV Bracket (118) with

 

Wires

 

four M4 x 12mm Screws (115). Start all four

 

Screws before tightening them.

117

 

Carefully pull the wires tight, and then tighten the

 

114

 

Cable Tie (99) around the wires.

99

Re-attach the Wire Cover (117) with the #8 x

118

 

1/2" Machine Screw (114).

 

 

 

 

15

 

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT QUESTIONS?Model No. PFTL20511.0 Serial No Call TOLL-FREETable of Contents Important Precautions Page Power Lines Before YOU Begin Part Identification Chart Make sure that the power cord is unplugged AssemblyAttach the Right Upright not shown See the inset drawing. Tie the wire tieBe careful not to pinch the Upright Wire Tighten the Screws yet. Note It may be helpBase Covers into place yet Page Again. if YOU do not Connect the CON Wire. See the inset drawing. The connectorsCable from the console assembly Should slide together easily and snap intoPage Make sure that the caps remain in the ends Storage Latch Screws before tightening them TV Assembly Chest Heart Rate Monitor HOW to PUT on the Heart Rate MonitorCare and Maintenance TroubleshootingHOW to Connect the Treadmill HOW to Connect the Power CordUse a Surge Suppressor Ohm Catv Cable HOW to Connect AN AntennaOhm Flat Wire HOW to Connect AN External Source Using a Catv CableHdmi Console Operation and AdjustmentDiagram Features of the ConsoleHOW to USE the Touch Screen HOW to Turn on the PowerCreate an iFit Live account HOW to SET UP the ConsoleConnect to your wireless network Check for firmware updates Calibrate the incline systemHOW to USE the Manual Mode This, the treadmill’s electrical components may When you are finished exercising, removePower cord. Important If you do not do Key from the consoleHOW to USE AN Onboard Workout Select an onboard workoutStart the workout Select the main menu. See on Select a set-a-goal workout HOW to USE a SET-A-GOAL WorkoutStart the workout. See on HOW to USE AN Ifit Live WorkoutHOW to USE the Equipment Settings Mode HOW to USE the Maintenance Mode Exit the maintenance modeFind keycodes Exit the wireless network mode HOW to USE the Wireless Network ModeEnable Wi-Fi Set up and manage a wireless network connectionHOW to USE the Internet Browser HOW to USE the Stereo Sound SystemHOW to USE the Entertainment Mode HOW to Operate the 15 Digital TVHOW to Replace the Batteries in the Remote Control HOW to USE the Remote ControlAdjust the channel settings HOW to Adjust the Television SettingsAdjust the image settings Adjust the audio settingsExit the menu Adjust the parental control settingsSet up the basic television settings Adjust the advanced television settingsHOW to Lower the Treadmill for USE HOW to Fold and Move the TreadmillHOW to Fold the Treadmill HOW to Move the TreadmillSymptom The power turns off during use TroubleshootingTop View Symptom The walking belt slows when walked onSymptom The television is not receiving a signal Symptom The volume cannot be turned up Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesKey No. Qty Description Part ListExploded Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Ordering Replacement Parts Limited WarrantyIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Top Page Image Contents