Installation
Incorrect installation of the aerobar could cause you to lose control and fall from your bicycle. If you are not familiar with the installa- tion of aerobars, have your dealer install them.
Before installing your aerobar, read the Safety information. Note to Dealers: If you install this product
for the consumer, please provide him or her with this owner’s manual after installation of the aerobar.
Make sure this aerobar is compatible with your bicycle Some lightweight aluminum or carbon fiber handlebars are
not compatible with aerobar assemblies; refer to the handlebar manufacturer's installation instructions.
This aerobar is designed to fit handlebars with either a 26.0 mm or
31.8 mm stem clamp diameter using the following parts:
• For a 26.0 mm handlebar, use the four shims (two each, E and F, Figure 2) included with this aerobar assembly.
• For a 31.8 mm handlebar, no shims are required.
Tools and materials required:
• 3, 4, and 5 mm allen wrenches
• Torque wrench
To install the extension tubes to the handlebar
The following letter references (A, B, C, etc.) are for Figure 2. 1. Determine the desired aerobar width.
If needed, unwrap the top section of handlebar tape to attain the desired width.
11