Bontrager Race X Lite manual To install the arm pad holders and arm pads, To install shift levers

To install the arm pad holders and arm pads

The width of the arm pad holders can be customized to suit your body type and riding style.

1. Insert two arm pad holder screws (J) through the desired holes of the left and right arm pad holders (K) and into the pad width adjusters (L).

2. Tighten each arm pad holder screw to 30 lb•in (3.4 N•m). Two screws are required per side to prevent

the arm pad holders from spinning on the arm width adjusters.

3. Repeat on the second arm pad holder.

4. Place the arm pads on the hook-and-loop fasteners of the arm pad holders.

To install shift levers

If you wish to install bar end shift levers into the tip of the Race X Lite® extension tubes (A), slide the control cables and housing through the cable guide plug (N). Do not drill or cut the extension tubes. Tighten the shift lever mounting bolt until the shift lever is firmly in place.

Do not over tighten the shift lever mounting bolt as this may damage the carbon extension tube. Do not exceed 45 lb•in (5 N•m).

To check the installation

Re-check all fasteners for tightness after the first use of the aerobar and periodically thereafter to insure secure attachment of the aerobar.

13