Cateye EC-3600, EC-3700 service manual MS-20Replacing the Center Cover of Recumbent Type

Applicable Models: EC-3600 EC-3700

MS-20Replacing the Center Cover of Recumbent Type

*Remove the pulse rate sensor, if it is connected, before proceeding to the following procedures.

1.	Remove the control unit fixing screws (4 pieces) from the main
	unit. (Fig. 1)
2.	Detach the cable connector from the control unit. (Fig. 2)
3.	Loosen and remove the inner pipe from the joint metal base.
	(Fig. 3)
4.	Remove the frame cover fixing screws, and the frame cover
	will be separated into right and left parts. (Fig. 4)
5.	Remove the latch of the center cover from the frame cover,
	and pull the center cover toward the joint metal base to remove
	it. (Fig. 5)
6.	Assembling of the center cover can be performed in reversed
	procedure of the above.
	* Pull the 5P cable connector out of the center cover through

Control Unit

Control Unit Fixing Screw

Fig. 1

5P Cable

Fig. 2

Inner Pipe

Joint Metal Base

Fig. 3

the hole on the cover, and tentatively hold it with an

adhesive tape so that it may not be retracted.

Frame Cover

Fixing Screw

Frame Cover

Fig. 4

Center Cover

EC-

3600

Joint

Fig. 5

MS-20Replacing the Center Cover of Recumbent Type

Cateye Ergociser Series 1000 Service Manual

57