English
Adjusting the Subwoofer Output Level
You can adjust the subwoofer output level if you have selected “YES” for the “SUBWOOFER” (see page 15).
Once it has been adjusted, the receiver memorizes the adjustment.
Before you start, remember...
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
On the front panel: |
|
1. Press ADJUST repeatedly until | ADJUST |
“SUBWFR LEVEL” appears on |
|
the display. |
|
•Once you have pressed ADJUST, MULTI CURSOR %/ Þ can be also used for selecting “SUBWFR LEVEL.”
•The display changes to show the current setting.
2. | Press MULTI CURSOR @/ #to | MULTI CURSOR |
|
|
| ||
| adjust the subwoofer output level |
|
|
|
|
| |
From the remote control: | SOUND |
| |
|
|
| |
1. | Press SOUND. |
|
|
| The 10 keys are activated for sound adjustments. |
|
|
2. | Press SUBWOOFER | SUBWOOFER | |
| the subwoofer output level | 1 | 2 |
| to +10 dB). |
|
|
Attenuating the Input Signal
When the input level of the playing source is too high, the sounds will be distorted. If this happens, you need to attenuate the input signal level to prevent the sound distortion.
On the front panel ONLY: |
|
Press and hold INPUT ATT. (ONE TOUCH | INPUT ATT. |
| ONE TOUCH OPERATION/ |
OPERATION) so that the ATT indicator |
|
lights up on the display. |
|
•Each time you press and hold the button, the Input Attenuator mode turns on (“INPUT ATT ON”) or off (“INPUT NORMAL”).
Notes:
•This function is available only for the sources connected using the analog terminals.
•This function does not take effect when digital input is selected.
Reinforcing the Bass
With this Bass Boost function, you can boost the bass level.
Before you start, remember...
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press ADJUST repeatedly until | ADJUST |
“BASSBOOST” (with the current |
|
setting) appears on the display. |
|
•Once you have pressed ADJUST, MULTI CURSOR %/ Þ also can be used for selecting “BASSBOOST.”
2. Press MULTI CURSOR @/ #to | MULTI CURSOR |
switch this function “ON” or |
|
“OFF.” |
|
• When this function is switched “ON,” the BASS BOOST indicator on the display lights up.
Note:
The Bass Boost function affects the front speaker sounds only.
Adjusting the Tone
You can adjust the treble and bass sounds as you like.
Before you start, remember...
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press ADJUST repeatedly until | ADJUST |
| |
“BASS” or “TREBLE” appears on |
|
the display. |
|
•Once you have pressed ADJUST, MULTI CURSOR %/ Þ can be also used for selecting “BASS” or “TREBLE.”
•Select “BASS” to adjust the bass sound level.
•Select “TREBLE” to adjust the treble sound level.
2. Press MULTI CURSOR @/ #to | MULTI CURSOR |
adjust the bass or treble sound |
|
level within the range of |
|
+10. |
|
•Each time you press the button, the sound level changes by ± 2 steps.
10