Troubleshooting
Use this chart to help you solve daily operational problems. If there is any problem you cannot solve, contact your JVC service center.
| PROBLEM | POSSIBLE CAUSE | SOLUTION | |
|
|
|
|
|
| The display does not light up. | The power cord is not plugged in. | Plug the power cord into an AC outlet. | |
|
|
|
|
|
| No sound from speakers. | Speaker signal cables are not connected. | Check speaker wiring and reconnect if | |
|
|
| necessary. | |
|
|
|
|
|
|
| The SPEAKERS 1 and 2 buttons are not | Press SPEAKERS 1 and 2 correctly. | |
|
| set correctly. |
|
|
|
|
|
|
|
|
| An incorrect source is selected. | Select the correct source. | |
|
|
|
|
|
|
| Muting is activated. | Press MUTING to cancel the mute. | |
|
|
|
|
|
| Sound from one speaker only. | Speaker signal cables are not connected | Check speaker wiring and reconnect if | |
|
| properly. | necessary. | |
|
|
|
|
|
|
| The balance is set to one extreme. | Adjust the balance properly (see page 11). | |
|
|
|
|
|
| Continuous hiss or buzzing during FM | Incoming signal is too weak. | Connect an outdoor FM antenna or contact | |
| reception. |
| your dealer. | |
|
|
|
|
|
|
| The station is too far away. | Select a new station. | |
|
|
|
|
|
|
| An incorrect antenna is used. | Check with your dealer to be sure you have | |
|
|
| the correct antenna. | |
|
|
|
|
|
|
| Antennas are not connected properly. | Check connections. | |
|
|
|
|
|
| Occasional cracking noise during FM | Ignition noise from automobiles. | Move the antenna farther from automobile | |
| reception. |
| traffic. | |
|
|
|
|
|
| Howling during record playing. | Your turntable is too close to speakers. | Move speakers away from the turntable. | |
|
|
|
|
|
| “OVERLOAD” starts flashing on the | Speakers are overloaded because of high | 1. Press POWER on the front panel to turn off | |
| display. | volume. | the receiver. | |
|
|
| 2. Stop the playback source. | |
|
|
| 3. Turn on the receiver again, and adjust the | |
|
|
| volume. | |
|
|
|
|
|
|
| Speakers are overloaded because of short | Press POWER on the front panel to turn off | |
|
| circuit of speaker terminals. | the receiver, check the speaker wiring, then | |
|
|
| press it again to turn on the receiver again. | |
|
|
| If “OVERLOAD” does not disappear though | |
|
|
| speaker wiring is not | |
|
|
| your dealer. | |
|
|
|
| |
| Remote control does not work. | There is an obstruction in front of the | Remove the obstruction. | |
|
| remote sensor on the receiver. |
|
|
|
|
|
| |
|
| Batteries are weak. | Replace batteries. | |
|
|
|
|
|
English
33