Operating JVC’s Audio/Video Components, English

Operating JVC’s Audio/Video Components

You can operate JVC’s audio and video components with this receiver’s remote control, since control signals for JVC components are preset in the remote control.

English

IMPORTANT:

To operate JVC’s audio components using this remote control:

•You need to connect JVC audio components through the COMPU LINK-3 (SYNCHRO) jacks (see page 26) in addition to the connections using cables with RCA pin plugs (see page 5).

•Aim the remote control directly at the remote sensor on the receiver.

•If you use the buttons on the front panel to choose a source, the remote control will not operate that source. To operate a source with the remote control, the source must be selected using source selecting buttons on the remote control.

•To operate the cassette deck or MD recorder using the COMPU LINK remote control system, set the source name correctly. (See page 11.)

•Refer also to the manuals supplied with your components.

POWER

CATV/ SAT	TV	VCR	AUDIO
DVD TVSOUND/DBS VCR			SLEEP
CD	ANALOG/DIGITAL		PHONO
TAPE/MD			FM/AM

CATV

RECPAUSECONTROL

SURROUNDSOUND

SURROUND	CATV CH	VCR CH	CD-DISC
MODE			CD-DISC
SUBWOOFER		CNTR
1	2	3	4
REAR•L		REAR•R
5	6	7/P	8
EFFECT	TEST	MENU	ENTER
9	0	10	+10
TV/VIDEO		RETURN	100+
TV/VIDEO
MUTING	TV CH	TV VOL	VOLUME
MUTING

RM-SRX6500J REMOTE CONTROL

Sound control section (Amplifier)

You can always perform the following operations:

SURROUND:Turns on or off the Surround modes — Dolby Pro Logic, Dolby Digital, and DTS Digital Surround.

SURROUND MODE: Selects the DSP modes.

After pressing SOUND, you can perform the following operations:

SUBWOOFER –/+: Adjusts the subwoofer output level.

CNTR –/+:	Adjusts the center speaker output level.
REAR•L –/+:	Adjusts the left rear speaker output level.
REAR•R –/+:	Adjusts the right rear speaker output level.
EFFECT:	Selects the effect level.
TEST:	Turns on or off the test tone output.

Note:

After adjusting sounds, press the corresponding source selecting button or CD-DISC to operate your target source by using the 10 keys; otherwise, the 10 keys cannot be used for operating your target source.

Turntable

After pressing PHONO, you can perform the following operations on a turntable:

3:	Starts playing.
7:	Stops operations.

CD player

After pressing CD, you can perform the following operations on the CD player:

3:	Starts playing.
4:	Returns to the beginning of the current (or
¢:	previous) track.
¢:	Skips to the beginning of the next track.
7:	Stops playing.
8:	Pauses playing. To release it, press 3.
1 – 10, +10:	Selects a track number directly.
	For track number 5, press 5.
	For track number 15, press +10, then 5.

For track number 20, press +10, then 10.

For track number 30, press +10, +10, then 10.

Tuner

After pressing FM/AM, you can perform the following operations:

FM/AM: Alternates between FM and AM.

1 – 10, +10: Selects a preset channel number directly. For channel number 5, press 5.

For channel number 15, press +10, then 5. For channel number 20, press +10, then 10.