Setting the Subwoofer Information
Register whether or not you have connected a subwoofer.
Before you start, remember...
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press SETTING repeatedly until | SETTING |
| |
“SUBWOOFER” appears on the |
|
display.
•Once you have pressed SETTING, MULTI CURSOR %/ Þ can be also used for selecting “SUBWOOFER.”
•The display changes to show the current setting.
MULTI CURSOR
2.Press MULTI CURSOR @/ #to select “YES” or “NO.”
YES: Select this when a subwoofer is used.
NO: Select this when no subwoofer is used.
Storing the Basic Settings and
Adjustments — One Touch Operation
JVC’s One Touch Operation function is used to assign and store different sound settings for each different playing source. By using this function, you do not have to change the settings every time you change the source. The stored settings for the newly selected source are automatically recalled.
To cancel the One Touch Operation function
Press ONE TOUCH OPERATION (INPUT ATT.) so that the ONE TOUCH OPERATION indicator goes off.
(Even though the One Touch Operation function is canceled, the recalled sound effects remain active.)
Note:
If the source is FM or AM, you can assign a different setting for each
band.
Using the Sleep Timer
Using the Sleep Timer, you can fall asleep to music and know the receiver will turn off by itself rather than play all night.
From the remote control ONLY:
Press SLEEP repeatedly. | SLEEP |
The SLEEP indicator lights up on the display, and the
10 
20 
30 
40 
50 
60 
70 
80 
90
00(Canceled) 
When the
The receiver turns off automatically.
To check or change the time remaining until the
Press SLEEP once.
The remaining time until the
• To change the
To cancel the Sleep Timer
English
The following can be stored for each source:
•Volume level (see page 9)
•Bass boost (see page 10)
•Tone adjustment (see page 10)
•Input attenuator mode (see page 10)
•Subwoofer output level (see page 10)
•Balance (see page 11)
•DSP modes
–
–DAP mode settings (see page 21)
–Surround mode settings (see page 22)
On the front panel ONLY:
To store the sound settings
1.Press ONE TOUCH OPERATION (INPUT ATT.) so that the ONE TOUCH OPERATION indicator lights up on the display.
ONE TOUCH OPERATION/
INPUT ATT.
Press SLEEP repeatedly until “SLEEP 00min.” appears on the display. (The SLEEP indicator goes off.)
• Turning off the power also cancels the Sleep Timer.
2. Adjust the sound using the functions listed above.
The newly adjusted settings are memorized.
To recall the sound settings
With the ONE TOUCH OPERATION lamp lit, the settings for the currently selected source are recalled when the source is selected.
15