JVC RX-DP20VBKC manual Zone 1 speaker layout, Front speakers and center speaker

Front speakers 1	Center speaker
Right / Left

IMPORTANT:

After connecting the speakers, set the speaker setting information properly:

•To obtain the best possible Surround/THX/DSP effect in Zone 1, see “Basic Settings” on pages 35 to 44.

•To connect the speakers to the FRONT 2/ZONE 2 SPEAKERS terminals, set the speaker usage correctly.

(See “w Setting the Zone 2/Speakers 2 Usage—ZONE 2/ SPEAKER 2” on page 43.)

FRONT 1 SPEAKERS

CAUTION : +

SPEAKER

IMPEDANCE

FRONT 1 AND 2

/ZONE 2:

8 16

FRONT 1 OR 2: – 4 16

RIGHTLEFT

FRONT 2 /	CENTER
ZONE 2 SPEAKERS
	SPEAKER

RIGHTLEFT

CAUTION : SPEAKER IMPEDANCE 8 16

SURROUND	SURROUND BACK
SPEAKERS	SPEAKERS

+

–

RIGHT LEFT RIGHT LEFT

	Right /	Left	Right / Left
	Surround speakers		Surround back
			speakers*
Right / Left	*	When using only one surround back speaker,

Front speakers 2 connect it to the LEFT terminals.

Zone 1 speaker layout

Ideal speaker layout varies depending on the conditions of your listening room. The diagram below is a recommended typical example.

Subwoofer

Left front speaker(s)		Right front speaker(s)
(L)	Center speaker		(R)
		(C)

Left surround	Right surround
speaker (LS)	speaker (RS)

Surround back speakers (LSB/RSB)

Front speakers and center speaker

•Place these speakers (position of the mid-range speaker units) at the same height from the floor.

•Place these speakers aiming at the listener’s ears.

Surround and surround back speakers

•Place these speakers at a position which is 1 meter higher than the listener’s ears.

•Point these speakers down aiming at the listener’s ears.

L	C	R
30˚	30˚	Subwoofer
90˚		90˚
LS		RS
60˚		60˚

LSBRSB

Note:

Ideal speaker layout requires that all speakers be placed at the same distance from the listener. However, since in some places it may be difficult to fulfil this requirement, this unit can adjust the delay time so that the sounds through all the speakers reach the listener with the same timing. (See page 40.)

9