JVC RX-DP20VBKC manual Attenuating the Input Signal, Muting the Zone 1 Sound, Analog

DIGITAL AUTO : Select this for the digital input mode. The receiver automatically detects the incoming signals.

The DGTL AUTO indicator lights up on the display, and the digital signal format indicators for the detected signals also light up.

ANALOG	: Select this for the analog input mode.
	The ANALOG indicator lights up.

When selecting “DIGITAL AUTO,” the following indicators indicate the digital signal format of the incoming signal.

LINEAR PCM : Lights up when Linear PCM signals come in.

DIGITAL : Lights up when Dolby Digital or Dolby Digital EX signals come in.

: Lights up when DTS or DTS-ES signals come in.

No indicator lights up when the receiver cannot recognize the digital signal format of the incoming signals.

When playing software encoded with the Dolby Digital or DTS

Surround, the following symptoms may occur:

•Sound does not come out at the beginning of playback.

•Noise comes out while searching for or skipping chapters or tracks.

Attenuating the Input Signal

When the input level of the playing source is too high, the sounds will be distorted. If this happens, you need to attenuate the input signal level to prevent sound distortion.

•You have to make this setting for analog each source.

On the unit ONLY:

Press and hold INPUT ATT (inside the
	INPUT MODE
front door) so that the INPUT ATT	/ INPUT ATT
indicator lights up on the display.

•Each time you press and hold the button, the

input attenuator mode turns on (“INPUT ATT ON”) or off (“INPUT ATT OFF”).

INPUT ATT indicator

ANALOG		SPEAKERS	1
L	R
SUBWFR		INPUT ATT	VOLUME
			dB
ANALOG		SPEAKERS	1
L	R
SUBWFR			VOLUME

dB

Ex. When the source is “VIDEO.”

Notes:

•This effect is applied to only the Zone 1 analog sources.

•This function is not valid when Analog Direct is in use.

In this case, press RIGHT (or LEFT) on the unit to select “DGTL DOLBY D” or “DGTL DTS” while “DIGITAL AUTO” still remains on the display.

•Each time you press the button, the input mode changes as follows:

	DGTL AUTO
L C R	SPEAKERS	1

Muting the Zone 1 Sound

From the remote control ONLY:

Press MUTING to mute the sound through all speakers in Zone 1 and headphones connected.

MUTING

SUBWFR	LFE	DIGITAL	VOLUME
LS	RS

dB

DIGITAL AUTO DGTL DOLBY D

(DOLBY DIGITAL)

DGTL DTS

(DTS SURROUND)

When “DOLBY DIGITAL” or “DTS SURROUND” is selected,

the DGTL AUTO indicator goes off, and the corresponding digital

signal format indicator ( DIGITAL or ) lights up on the display.

•If the incoming signal does not match the selected digital signal format, the frame of the selected indicator will flash.

Note:

When you turn off the power or select another source, “DOLBY DIGITAL” and “DTS SURROUND” settings are canceled and the digital input mode is automatically reset to “DIGITAL AUTO.”

“MUTING” appears on the display and the volume turns off (the VOLUME level indicator goes off).

	ANALOG	SPEAKERS	1
L	R

SUBWFR

Ex. When the source is “VIDEO.” The VOLUME level indicator goes off.

To restore the sound, press MUTING again so that “MUTING OFF” appears on the display for a while.

•Turning MASTER VOLUME on the unit or pressing VOLUME +/– on the remote control also restores the sound.

	ANALOG	SPEAKERS	1
L	R
SUBWFR			VOLUME

dB

26