JVC RX-DP20VBKC manual Putting Batteries in the Remote Control, Replace the cover, LR6AM3 L4015A

3.Connect the plug of the transmitter to the IR OUT jack of the receiver and attach the transmitter.

Target component(s)

Less					COMPU	AV	TEXT	IR	CTRL
	than				LINK-4	COMPU	COMPU	OUT	OUT
		3			(SYNCHRO)	LINK-	LINK		+12V
			m	(10
					feet)
								IR	10mA MAX
								IN

At an angle of

approx. 60°

Signal-emitting angle of the transmitter
Horizontally: 60˚	Vertically: 60˚
	15°
	45°
30°
30°

Putting Batteries in the Remote Control

Before using the remote control, insert the two supplied batteries

first.
1	2	3
	LR6(AM3)
	/L40(15A)

1.On the back of the remote control, remove the battery cover.

2.Insert the batteries.

• Make sure to match the polarity: (+) to (+) and (–) to (–).

3.Replace the cover.

If the remote control cannot transmit signals or operate the receiver correctly, replace the batteries. Use two LR6(AM3)/L40(15A) type (alkaline) dry-cell batteries.

Connecting the Power Cord

Before plugging the receiver into an AC outlet, make sure that all connections have been made.

Connect one end of the power cord to the AC IN socket on the rear (1) and the other end into an AC outlet (2) .

1	2
	AC IN

Keep the power cord away from the connecting cables and the antenna. The power cord may cause noise or screen interference.

Note:

The preset settings such as preset channels and sound adjustment may be erased in a few days in the following cases:

–When you unplug the power cord.

–When a power failure occurs.

CAUTIONS:

•Do not touch the power cord with wet hands.

•Do not pull on the power cord to unplug the cord.

When unplugging the cord, always grasp the plug so as not to damage the cord.

Notes:

•If you aim the remote control directly at the remote sensor on the receiver, you can operate the receiver at a distance of up to 7 m (23 feet).

•When replacing the batteries, finish changing them without delay; otherwise, the stored signals are all erased (see pages 74 to 80).

When using the remote control in the dark

Press LIGHT.

LIGHT

The buttons on the remote control are backlit while you are using the remote control.

If you do not press any button for about 5 seconds, the backlight will turn off.

CAUTIONS:

Follow these precautions to avoid leaking or cracking cells:

•Place batteries in the remote control so they match the polarity:

(+) to (+) and (–) to (–).

•Use the correct type of batteries. Batteries that look similar may differ in voltage.

•Always replace both batteries at the same time.

•Do not expose batteries to heat or flame.

18