Weider 831.159380 user manual Assembly, Arm

Page 10

15. See the inset drawing. Attach the Military

Press Arm (84) to the Pivot Arm (101) with

two 5/16” x 2 1/4” Bolts (33) and two 5/16”

Nylon Locknuts (3).

Press two 1 1/2” Square Inner Caps (32) into

the Military Press Arm (84). Press two 1”

Round Inner Caps (49) into the Military Press

Arm. Slide two 5” Plastic Handgrips (83) onto

15

32

49

32

21

84

the Military Press Arm.

Attach the Pivot Arm (101) to the Assist

Upright (74) with a 3/8” x 3 1/4” Bolt (67) and

101

67

83

ASSEMBLY

a 3/8” Nylon Locknut (21).

74

56

33

101

84

3

ARM

16.Press two 1” x 2” Inner Caps (107) into the Assist Arm (105).

Attach the Assist Arm (105) to the Leg Press Upright (56) with a 3/8” x 6” Bolt (106), two 3/8” Flat Washers (9), and a 3/8” Nylon Locknut (21). See the inset drawing. The

Assist Arm must be attached to the lowest hole in the Leg Press Upright (56). The Assist Arm must also be below the welded bracket on the Assist Upright (74).

16

74

Bracket

105

74 56

56

106107

9

9

105

21

10

Image 10

Contents Model No Serial No Patent PendingSEARS, Roebuck and CO., Hoffman ESTATES, IL Table of Contents Important PrecautionsBefore YOU Begin Using the Weider PRO 9645 Home Gym SystemFor your benefit, read this manual carefully before Following Tools not Included are Required for Assembly AssemblyFrame Assembly Frame AssemblyLocknuts yet Weights 25 until is complete Stabilizer 5. Stack eight Weights ontoStack of Weights Tighten all Nylon Locknuts used in stepsWeight Tube is sitting in the pin grooves in the top WeightBe sure that the pin on the Weight Be sure that the holes in the WeightLocate and open the parts bag labeled ARM Assembly Arm must be able to pivot freelyDo not tighten the Nylon Locknut yet On each Arm. Arm identification is veryImportant for step Arm with the Left Arm 47 refer to stepAssembly ARMARM Assembly Cable Assembly Long Cable Trap is positioned to hold the Cable in place Bracket Cable Cable Assembly Cable Assembly That the Cable Trap is positioned to hold Must be inserted from the side shownThat the Pulley is on the side shown Cable in placeCable Assembly Seat Assembly Locate and open the parts bag labeled Seat AssemblySeat Are not properly installed, they may be Rect the problem. Important If the cablesDamaged when heavy weight is used. See HOW to USE the Home GYM System Changing the Weight SettingAttaching and Removing the Seat Adjusting the LEG Press PlateAttaching the LEG Lever to the LOW Pulley Station Weight Resistance Chart PlatesTROUBLE-SHOOTING and Maintenance Tightening the CablesHigh Cable Cable DiagramsHigh Cable 58 and Low Cable Low CableMilitary Press Cable 72 and Leg Press Cable Pivot Arm Leg Press CablePage Page X 3 1/4 Bolt Key Part Qty Description R1096AKey Part Exploded DRAWING-Model No Model No Full 90 DAY WarrantySEARS, Roebuck and CO., Dept WA, Hoffman ESTATES, IL